4M-1751-005w_G5S - 第67页
4OM-1751 1-17 (Front Side of Machine) (Rear Side of Machine) Nozzle Stocker Section PCB Positioning Section Head Section XY Beam Section Component Recognition Camera Section Cutter Section Feeder Base Driving Section F4A…
4OM-1751
1-16
3. Maintenance Spots
3.1 Whole View
Notice
Any operations with a cover(s) being removed are included.
After the maintenance work, be sure to attach the cover.
Front View of Machine
Air Source
Vacuum System
Feeder Cart Section
F4A6
Reference
(a) Refer to "3.2" in "Chapter 1" and the subsequent items for the detailed
information on the spots of each section to be maintained and how to
maintain them.
(b) As for the options, refer to each instruction manual of the specially
1304-001
3. Maintenance Spots
4OM-1751
1-17
(Front Side of Machine)
(Rear Side of Machine)
Nozzle Stocker Section
PCB Positioning Section
Head Section
XY Beam Section
Component Recognition
Camera Section
Cutter Section
Feeder Base Driving Section
F4A7
1304-001
3.1 Whole View
4OM-1751
1-181304-001
4. Inspection, Cleaning, and Lubrication Spots
The following describes about the maintenance tasks required for each individual
units.
Reference
Refer to "2. Maintenance Check List" in "Chapter 1" for the maintenance items
4.1 Air Source
4.1.1 Air Blow Pressure Check
Cycle : Every Day (Required Time : 1 minute)
Air Blowing Pressure
F4A8
Procedure
Check to see that the pressure gauge reads the initial setting (0.05 MPa
(0.5 kgf/cm
2
)). Do not change the pressure unless necessary.
Notice
The pressure is factory-adjusted upon shipment of the machine.
4. Inspection, Cleaning, and Lubrication Spots