4M-1751-005w_G5S - 第75页
4OM-1751 1-25 4.3 Component Recognition Camera Section 4.3.1 Component Recognition Camera Cleaning NOTICE Do not put your hand onto the reference mark block. If too much force is given to the reference mark block it may …
4OM-1751
1-241304-001
4.2.2 Filter Cleaning
Cycle : Every 3 Months (Required Time : 10 minutes)
Filter Case
C
Filter
F4A15
Procedure
(1) Remove four setscrews fastening the cover located at the lower area of the
front side of the machine and detach the cover.
Note
When the vacuum pressure has dropped during the operation, replace the
(4) Attach the cover and tighten the setscrews.
Notice
If a clearance is left between the main machine and the cover, the
tape will pop out from the clearance during the operation, causing
the machine to breakdown or generate an error.
4.2 Vacuum System
4OM-1751
1-25
4.3 Component Recognition Camera Section
4.3.1 Component Recognition Camera Cleaning
NOTICE
Do not put your hand onto the reference mark block.
If too much force is given to the reference mark block
it may become deformed.
Notice
Be sure to use a suction force such as a vacuum cleaner for the
cleaning.
Do not blow air to any cleaning section with an air gun.
When air is blown, the dirt and dust inside the machine will disperse,
causing the recognition system and the machine to malfunction.
Fiducial Mark Block
Component Recognition Camera
(2 locations)
Every Day Cleaning
Required Time: 4 minutes
Remove the components that have fallen with a
pair of vacuum tweezers and wipe off dust with
a lens cleaning cloth.
F4A16
Note
G -S047-01 Adhesive Cleaner (Part No: 226J2091) is also available as an option
Adhesive Cleaner
F4A17
1304-001
4.3 Component Recognition Camera Section
4OM-1751
1-26
4.3.2 Rejected Component Box Cleaning
NOTICE
Before removing the accumulated components from
the box, eliminate the static electricity from your
body.
Otherwise, some components may be damaged due
to static electricity.
Fiducial Mark Block
Component Storage Box
Every Day Cleaning
Required Time: 1 minute
Remove components collected in the box.
Hanenaito (Vibration Proof Rubber)
Every Day Cleaning
Required Time: 1 minute
Take out Hanenaito from the component
storage box and clean it with a vacuum cleaner.
F4A18
Rejected Component Box Base
Every Day Cleaning
Required Time: 1 minute
In the case that there is any foreign substance
dropped on to the base section, remove it.
Rejected Component Box
Detection Sensor (Rear Side)
Every Day Cleaning
Required Time: 1 minute
Clean the sensor using a cotton applicator.
F4A18-1
1312-003
4.3 Component Recognition Camera Section