Einsteckerlösung an BE Wagen S-F - 第32页
2 Retrofit instructions for single plug solution for compo nent trolleys on S/F machines (item no.: 00166164-01) Special Design 10/2005 Edition 32 2.7 W ork on the machine 2.7.1 Fitting the adapter : Remove the cover pla…
Special Design 2 Retrofit instructions for single plug solution for component trolleys on S/F machines (item no.: 00166164-01)
10/2005 Edition
31
: Fix the signal cable using a cable tie and refit the front panel using six screws.
2
Make sure that the LED (SW MN; 00328703-xx) fits into the front panel. 2
2
2
2
: Remove the table adapter from the previous air hose.
2
: Run the new air hose beside the cables so that the air hose is connected, beneath the table
bed, with the existing, shortened air hose.
: Fix the cables and the air hose beneath the table bed using a cable tie.
2
Do not overtighten the cable tie - leave a little slack. 2
2
2
LED
2 Retrofit instructions for single plug solution for component trolleys on S/F machines (item no.: 00166164-01) Special Design
10/2005 Edition
32
2.7 Work on the machine
2.7.1 Fitting the adapter
: Remove the cover plate and drill 4 holes. Cut an M5 thread. The dimensions are shown on the
enclosed drilling pattern.
2
The holes must be drilled and the thread cut with the cover plate removed, otherwise cables be-
hind it may be damaged. 2
2
2
2
2
Special Design 2 Retrofit instructions for single plug solution for component trolleys on S/F machines (item no.: 00166164-01)
10/2005 Edition
33
2
: Refit the cover plate. Then check that the side doors and the protective cover are working cor-
rectly.
: Fit the adapter to the front of the cover plate.
2
82
vorhandene Bohrungen
4 x M5
Oben
2 x M4
300
+
-
2
+
-
0,3
45
+
-
0,3
(62,5 )
(125 )
Group of thread holes for adapter
housing in the cover plate.
Drill only with removed plate!