ISM-1100_INM - 第23页
Quick reference handbook Barcode Reader software Quick reference handbook Barcode Reader software rev_6 Edition 06/2017 - Reproduction forbidden Page 23 RUGOSITY IDENT. SETTINGS TAB ( only for 180 0/3600 machine ) To che…
Quick reference handbook Barcode Reader software
Quick reference handbook Barcode Reader software rev_6 Edition 06/2017 - Reproduction
forbidden
Page 22
HUE Red/Blue/Yellow: if the camera recognizes a saturation over 30%, it
considers the chromatic scale to detect the colour.
In case of the low Hue value, the detected colour will be detected as yellow.
Label: When the colour is correctly detected, the barcode reader shows you a
dialog box specifying the colour, the Hue value and the saturation. It is always
possible to change the viewed label of the colour and assign another name but
normally these labels never change.
Identification area
This session is very important because allows you to specify the area where the
camera has to search the colour and the code.
To set the area, click on “Edit searching areas”: we would like to remind that it is
better to set a little red square.
The little red square shows you the already selected area (normally it is set on the
left side on the corner).
To check if the Barcode and Colour settings are correct, the technician can test
them using the TESTER button: the TESTER button for ISM1100/2000 machines is
different than the TESTER for Ultraflex machine.
Quick reference handbook Barcode Reader software
Quick reference handbook Barcode Reader software rev_6 Edition 06/2017 - Reproduction
forbidden
Page 23
RUGOSITY IDENT. SETTINGS TAB (only for 1800/3600 machine)
To check the presence of material, the program will check the roughness of the
material. As default, the roughness algorithm brightness threshold is 150: if the
value is higher than 150, for the barcode reader there is a reel.
Quick reference handbook Barcode Reader software
Quick reference handbook Barcode Reader software rev_6 Edition 06/2017 - Reproduction
forbidden
Page 24
To recognize the presence of material, the barcode reader module compares with
the pictures just taken to images saved in this following path:
C:\AutoSMD\BarCodeReader\multiplereels_reference
If there are any pictures as reference, it is necessary to save them following these
steps:
- insert a, empty case into the accumulator
- move up the lift
- select “Save current image as reference”
In case of Ultraflex 7+15, at the end of the operation, the technician should find:
- 1 reference image for 7” empty case
- 1 reference image for 15” empty case