00195722-0102_UM_X-Serie_SR605_EN - 第224页
3 Technical data for the machine User Manual SIPLACE X-Series 3.11 SIPLACE X-series component trolley From software version SR.605.xx 07/2008 EN Edition 224 3.1 1.10 Used t ape channel - CO tr olley docking unit, SIPLACE…
User Manual SIPLACE X-Series 3 Technical data for the machine
From software version SR.605.xx 07/2008 EN Edition 3.11 SIPLACE X-series component trolley
223
3.11.8.2 Maximum tape reel diameter in relation to the PCB conveyor height
3
PLEASE NOTE: 3
X-series component trolleys do not generally need spindles. However, if the "Timeout" error mes-
sage occurs increasingly on the X feeder module, we recommend that you do use spindles.
3.11.9 Waste tape chute, SIPLACE X-series
3
Fig. 3.11 - 10 Used tape chute for the component trolley docking unit from the SIPLACE X-series
Depending on the PCB conveyor height, the length of the waste tape chute can be set so that the
pieces of tape are diverted directly into the waste tape container of the component trolley.
PLEASE NOTE 3
The used tape chute for the X-series can only be installed on the component trolley docking unit
for the X-series (see Fig. 5.11 - 3, page 360).
Without mount for the
additional tape reel
With mount for the
additional tape reel
PCB conveyor
height
of the CO trolley
Tape reel diameter Tape reel diameter
without spindle with spindle
830 mm 17" 15" < 15"
900 mm 19" 17" 15"
930 mm 19" 19" 17"
950 mm 19" 19" 19"
3 Technical data for the machine User Manual SIPLACE X-Series
3.11 SIPLACE X-series component trolley From software version SR.605.xx 07/2008 EN Edition
224
3.11.10 Used tape channel - CO trolley docking unit, SIPLACE X-series
In the standard version, the used tape channel can guide component tapes with a maximum
pocket height of 12 mm to the pneumatic tape cutter.
3
Fig. 3.11 - 11 Used tape channel - CO trolley docking unit, SIPLACE X-series
(1) Inlet slot for the used tapes
(2) Outlet slot for the used tape above the pneumatic tape cutter
(3) Dividing plate for tapes < 12 mm (can be removed for tapes > 12 mm)
PLEASE NOTE
– The separating plate (item 3 in Fig. 3.11 - 11
) can be removed for tape pockets higher than
12 mm (see Section 4.6.1
, page 315).
→ Do not position feeder modules with shallow pockets immediately beside feeder modules with
deep pockets. The used tapes could overlap and build up.
User Manual SIPLACE X-Series 3 Technical data for the machine
From software version SR.605.xx 07/2008 EN Edition 3.12 SIPLACE HF component trolley
225
3.12 SIPLACE HF component trolley
Item no. 00119622-xx Component trolley, SIPLACE HF/X-series/D3
Up to four SIPLACE HF component trolleys can be docked into the machines from the SIPLACE
X-series. The locations are numbered as shown in the diagram below.
3
Fig. 3.12 - 1 Component trolley locations, SIPLACE HF
(1) Location 1
(2) Location 2
(3) Location 3
(4) Location 4
(T) PCB direction of travel
PLEASE NOTE 3
The SIPLACE HF component trolley cannot be used together with the 20-segment Collect&Place
head.