00195722-0102_UM_X-Serie_SR605_EN - 第243页

User Manual SIPLACE X-Series 4 Setting up and commissioning From software version SR.605.xx 07/2008 EN Edition 4.1 Transport and Delivery Configur ation 243 4 Fig. 4.1 - 3 Contact surfaces - Forks parallel to the directi…

4 Setting up and commissioning User Manual SIPLACE X-Series

4.1 Transport and Delivery Configuration From software version SR.605.xx 07/2008 EN Edition

242

4.1.5.3 Points for attaching the fork-lift on the placement machine

The next two diagrams show the fork-lift attachment points on the placement machine if you want

to lift the machine from the pallet or transport it without a pallet.

PLEASE NOTE 4

Always use a pallet and fork-lift to transport the placement machine over longer distances in

order to avoid damaging the machine.

Forks parallel to the PCB conveyor 4

WARNING 4

Please note the following points before you raise the placement machine in order to avoid irre-

versible damage to the machine:

– Open the forks just wide enough to position them between the two machine feet (the attach-

ment points are shown in Fig. 4.1 - 3

, page 243). The machine feet are 776 mm apart. NEVER

increase the distance between the forks so that the machine is lifted on the side parts of the

machine frame, since this would deform the machine frame.

→ Make sure that the forks are evenly loaded when you lift the machine. A firm support between

the forks and placement machine will prevent the machine tilting when it is raised. This will

also prevent a one-sided load on the machine feet, which would deform the fixing of the ma-

chine feet. We recommend that a second person watch the machine as it is raised, and make

sure that the machine does not tip to one side when lifted with the fork-lift.

User Manual SIPLACE X-Series 4 Setting up and commissioning

From software version SR.605.xx 07/2008 EN Edition 4.1 Transport and Delivery Configuration

243

Fig. 4.1 - 3 Contact surfaces - Forks parallel to the direction of PCB transport

(1) Contact surfaces for the forks of the fork-lift

4 Setting up and commissioning User Manual SIPLACE X-Series

4.1 Transport and Delivery Configuration From software version SR.605.xx 07/2008 EN Edition

244

Forks across the PCB conveyor 4

Fig. 4.1 - 4 Contact surfaces - Forks across the direction of PCB transport

(1) Contact surfaces for the forks of the fork-lift

WARNING 4

Please note the following points before you raise the placement machine in order to avoid irre-

versible damage to the machine:

– The distance between the forks must be between 800 and 900 mm. The attachment surfaces

for the fork-lift are shown in Fig. 4.1 - 4

. The maximum distance between the contact surfaces

is 1120 mm. NEVER increase the distance between the forks so that the machine is lifted on

the side parts of the machine frame, since this would deform the machine frame.