00195722-0102_UM_X-Serie_SR605_EN - 第301页
User Manual SIPLACE X-Series 4 Setting up and commissioning From software version SR.605.xx 07/2008 EN Edition 4.3 Setting up the placement machine 301 4.3.16 Integrating the placem ent machine into the line → Note the w…
4 Setting up and commissioning User Manual SIPLACE X-Series
4.3 Setting up the placement machine From software version SR.605.xx 07/2008 EN Edition
300
4.3.15.6 Machine foot clearances for the placement machine and WPC
4
4
4
4
Fig. 4.3 - 27 Machine foot clearances for the placement machine and WPC in millimeters
User Manual SIPLACE X-Series 4 Setting up and commissioning
From software version SR.605.xx 07/2008 EN Edition 4.3 Setting up the placement machine
301
4.3.16 Integrating the placement machine into the line
→ Note the warning instructions described in Section 4.3.2, page 255.
→ The tools and equipment are listed in Section 4.3.3
, page 256.
4.3.16.1 Positioning the fork lift
4
Fig. 4.3 - 28 Contact surfaces - Forks across the direction of PCB transport
(1) Contact surfaces for the forks of the fork-lift
→ Position the fork-lift across the direction of PCB transport and open the forks far enough so
that the machine's contact surfaces lies evenly on the forks (see Fig. 4.3 - 28
).
4 Setting up and commissioning User Manual SIPLACE X-Series
4.3 Setting up the placement machine From software version SR.605.xx 07/2008 EN Edition
302
WARNING 4
Please note the following points before you raise the placement machine in order to avoid irre-
versible damage to the machine:
– The distance between the forks must be between 800 and 900 mm. The attachment surfaces
for the fork-lift are shown in Fig. 4.3 - 28
, page 301. The maximum distance between the con-
tact surfaces is 1120 mm. NEVER increase the distance between the forks so that the ma-
chine is lifted on the side parts of the machine frame, since this would deform the machine
frame.
→ Make sure that the forks are evenly loaded when you lift the machine. A firm support between
the forks and placement machine will prevent the machine tilting when it is raised. This will
also prevent a one-sided load on the machine feet, which would deform the fixing of the ma-
chine feet. We recommend that a second person watch the machine as it is raised, and make
sure that the machine does not tip to one side when lifted with the fork-lift.
4.3.16.2 Points that MUST be noted when transporting the machine
WARNING 4
When you are transporting the machine, make sure that all the feet are clear of the floor. If they
are not clear, the feet will drag along the floor or bump into obstacles. This could damage the
machine foot fixing in the machine frame.