00195722-0102_UM_X-Serie_SR605_EN - 第361页

User Manual SIPLACE X-Series 5 Tasks for the operating personnel From software version SR.605.xx 07/2008 EN Edition 5.11 Docking the component trolley in or out 361 CAUTION 5 The component trolleys for the SIPLACE X-se r…

5 Tasks for the operating personnel User Manual SIPLACE X-Series

5.11 Docking the component trolley in or out From software version SR.605.xx 07/2008 EN Edition

360

→ Remember that a component trolley with the full complement of feeder modules can tip over

sideways or forward on gradients of 20° or more.

→ Make sure that the surface on which the trolley is moved has a significantly smaller gradient.

→ Be careful not to collide with obstacles. The trolley could tip forward if it is traveling fast

enough.

5.11.4 Docking the X-series component trolley

Fig. 5.11 - 3 Component trolley and component trolley docking unit, SIPLACE X-series

(1) Component trolley docking unit, SIPLACE X-series

(2) Component trolley, SIPLACE X-series

(3) Locking latches

User Manual SIPLACE X-Series 5 Tasks for the operating personnel

From software version SR.605.xx 07/2008 EN Edition 5.11 Docking the component trolley in or out

361

CAUTION 5

The component trolleys for the SIPLACE X-series (Fig. 5.11 - 3

, page 360) and SIPLACE HF

(Fig. 5.11 - 6

, page 364) have different docking units. Each component trolley must therefore only

be docked into the correct docking unit. Be careful when you push CO trolley for the SIPLACE X-

series into the machine and make sure that the locking latches (item 3 in Fig. 5.11 - 3

, page 360)

do not bump into obstacles.

PLEASE NOTE 5

Cut the component tapes off flush with the front end of the X feeder modules before you dock in

the component trolley.

CAUTION 5

Check that the placement head is outside the range of the component trolley.

→ Carefully push the component trolley into machine as far as the stop.

PLEASE NOTE 5

Close the protective covers since the component trolley can only be docked in if the covers are

closed.

→ Press the relevant button on the input or output side of the machine (item 1, 2, 3 or 4 in Fig.

5.11 - 1

, page 358), until the trolley is docked in fully.

→ Push the sleeve (item 1 in Fig. 5.11 - 4

, page 362) up using both handles and swivel the han-

dle down (item 2 in Fig. 5.11 - 4

, page 362).

5 Tasks for the operating personnel User Manual SIPLACE X-Series

5.11 Docking the component trolley in or out From software version SR.605.xx 07/2008 EN Edition

362

Fig. 5.11 - 4 Component trolley X-series - swivel handles down

(1) Push sleeve up

(2) Fold handle down