X7056_Operating manual_en.pdf - 第152页
Operation Operating the safety fe atures 152 Inspection system X7056 | Operating manual | Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a WARNING Hazard of injury Burns caused by the motors for the PCB cl amping. When l…
Operation
Operating the safety features
151
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
Actuating
EMERGENCY
STOP
Perform the following work steps:
Press the EMERGENCY STOP button.
The power to the inspection system is switched off.
The monitor is switched off.
the UPS ensures the regulated shutdown of the system
computer.
Release the PCB clamping manually, see „Releasing the PCB
clamping of the AXI transport track“ (Page 152).
EMERGENCY STOP has been actuated.
Cancelling
EMERGENCY
STOP
Perform the following work steps:
1. Turn the EMERGENCY STOP button clockwise to unlock it.
2. Turn on the UPS devices.
The axes initialize.
The inspection system is ready to operate.
3. Start the Viscom software, see „Starting the Viscom software“
(Page 155).
The AOI software starts.
The AXI software starts.
EMERGENCY STOP has been cancelled.
Releasing the PCB Clamping
To remove a PCB from the AOI or AXI transport during STOP or
EMERGENCY STOP states, release the PCB clamping manually.
The work steps in detail:
Releasing the PCB clamping of the AOI transport track
Releasing the PCB clamping of the AXI transport track
Releasing the
PCB clamping
of the AOI
transport
track
Precondition:
The STOP mode is actuated.
Operation
Operating the safety features
152
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
WARNING
Hazard of injury
Burns caused by the motors for the PCB clamping.
When loosening the PCB clamping, use only the handwheel.
Perform the following work steps:
1. Open the front lift door.
The hand wheel for releasing the PCB clamping is below the
AOI transport track.
2. Push the transport track completely to the left to reach the
hand wheel.
3. Release the PCB clamping:
Turn the hand wheel clockwise to release the PCB clamping.
The PCB clamping is released.
Releasing the
PCB clamping
of the AXI
transport
track
To remove a PCB from the AOI or AXI transport during STOP or
EMERGENCY STOP states, release the clamping manually.
Precondition: The STOP mode is actuated.
Handwheel
Operation
Operating the safety features
153
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
Perform the following work steps:
1. Open the rear swing doors.
The hand wheel for releasing the PCB clamping is below the AXI
transport track.
2. Pull the transport track AXI completely to the back.
3. Release the PCB clamping:
Turn the hand wheel clockwise to release the PCB clamping.
The PCB clamping is released.
Protective barrier safety features
The front swing and lift doors, the rear swing doors, the lift gate,
the shutter and the side panels are protective barrier safety
features of the inspection system. Opening any of the doors, the
lift gate or the shutter during operation actuates the STOP mode.
Handwheel