X7056_Operating manual_en.pdf - 第188页
Maintena nce Lubricating the spindles and travel guides - AXI 188 Inspection system X7056 | Operating manual | Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a Lubricating the spindles and travel guides - AXI This section …
Maintenance
Lubricating the spindles and travel guides - AOI
187
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
WARNING
Hazard of injury
Turn off the system and secure it against accidental restart
before starting lubrication.
Perform the following work steps:
1. Check the guides and spindles for dirt and clean these compo-
nents as required.
2. Give the spindle threads and guides a thin coat of grease with
the brush.
3. Open and close the width adjustment, see „Installation“ >
„Adjusting the transport track width“ (Page 86).
4. Open and close the clamping.
5. Check if there is a visible grease film on the spindles and
guides.
6. Check the function and smoothness of the clamping and width
adjustment.
The spindles and guides are greased.
Maintenance
Lubricating the spindles and travel guides - AXI
188
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
Lubricating the spindles and travel guides
- AXI
This section describes the lubrication of spindles and guides for the
PCB clamping and width adjustment.
The following sections describe how to lubricate the spindles and
guides:
Transport track AXI
Lubricating spindles and guides
Transport track AXI
Transport track AXI, view from below
Lubricating spindles and guides
Required: Lubricating grease KP2K, NLGI class 2 according to DIN 51818
Brush
Legend
No. Name
1 Width adjustment spindles
2 Left register drive spindles and guides
3 Width adjustment spindles
4 Right register drive spindles and guides
1
2
4
3
Maintenance
Lubricating the spindles and travel guides - AXI
189
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
WARNING
Hazard of injury
Turn off the system and secure it against accidental restart
before starting lubrication.
Perform the following work steps:
1. Check the guides and spindles for dirt and clean these compo-
nents as required.
2. Give the spindle threads and guides a thin coat of grease with
the brush.
3. Open and close the width adjustment, see „Installation“ >
„Adjusting the transport track width“ (Page 86).
4. Open and close the clamping, see „Operation“ > „Releasing the
PCB clamping of the AXI transport track“ (Page 152).
5. Check if there is a visible grease film on the spindles and
guides.
6. Check the function and smoothness of the clamping and width
adjustment.
The spindles and guides are greased.