X7056_Operating manual_en.pdf - 第192页
Maintena nce Lubricating the flat panel detector positioni ng unit 192 Inspection system X7056 | Operating manual | Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a X - and Y -axis spindles Lubricating the runner blocks an…
Maintenance
Lubricating the flat panel detector positioning unit
191
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
Y-axis runner block
Legend
No. Name Size Numbe
r
Grease in cm3
1 Y-axis runner block 15 4 0.4
1
X
Y
Maintenance
Lubricating the flat panel detector positioning unit
192
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
X- and Y-axis spindles
Lubricating the runner blocks and spindles
Required: Lubricating grease KP2K, NLGI class 2 according to DIN 51818
Grease gun
Extension attachment, approx. 120 mm
Lubricating the
X-axis runner
block
Perform the following work steps:
1. Stand behind the inspection system and open the rear swing
doors.
2. Pull the X-axis toward yourself.
3. Check guide carriage and guide rails for contamination; clean if
required.
Legend
No. Name Numbe
r
Grease in cm3
1 X- and Y-axis spindles 2 1.5
1
X
Y
Maintenance
Lubricating the flat panel detector positioning unit
193
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
4. Grease the front guide runner block the lubricating nipple with
0.4 cm
3
grease.
5. Grease the rear runner block through the lubricating nipple with
0.4 cm
3
grease.
6. Move the runner blocks back and forth with three double
strokes; the distance should be equal to at least three times
the length of a runner block.
7. Check if there is a visible grease layer on the guide rails.
The X-axis runner blocks are lubricated.
Lubricating the
Y-axis runner
blocks
Perform the following work steps:
1. Stand behind the inspection system.
2. Pull the X-axis toward yourself.
3. Check guide carriage and guide rails for contamination; clean if
required.