X7056_Operating manual_en.pdf - 第208页
Maintena nce Exchanging the AOI transport belts 208 Inspection system X7056 | Operating manual | Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a 8. Mount the traverse by firmly tightening the 4 screws with the socket wren…
Maintenance
Exchanging the AOI transport belts
207
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
6. Install the clamping unit evenly, without tilting or bending.
7. Install the end stop guide rail by firmly tightening the 6 screws
with the socket wrench (3 mm Allen socket). Be absolutely
certain that the PCB overlap width value measured during the
disassembly is the same for the assembly.
Maintenance
Exchanging the AOI transport belts
208
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
8. Mount the traverse by firmly tightening the 4 screws with the
socket wrench (5 mm Allen socket).
The traverse must lie against the end stop.
9. Make sure the end stop rail guide catches on the traverse
correctly.
10.Repeat steps 1 to 9 for the transport belts on the movable
transport plate.
Maintenance
Exchanging the AOI transport belts
209
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
11.Place a PCB in the transport track and check whether the end
stop guide rails of the movable and the fixed transport side
plates are parallel to each other.
The transport belts are installed.
The AOI transport belts are exchanged.