X7056_Operating manual_en.pdf - 第218页
Maintena nce Exchanging the AX I transport bel ts 218 Inspection system X7056 | Operating manual | Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a 8. Mount the trav erse by tightening the screws on the movable transport p…
Maintenance
Exchanging the AXI transport belts
217
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
6. Install the end stop guide rail by firmly tightening the 8 screws
with the socket wrench (3 mm Allen socket). Be absolutely
certain that the PCB overlap width value measured during the
disassembly is the same for the assembly.
7. Install the clamping unit evenly, without tilting or bending.
Clamping unit
Maintenance
Exchanging the AXI transport belts
218
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
8. Mount the traverse by tightening the screws on the movable
transport plate with the socket wrench (5 mm Allen socket) and
the screws on the movable transport plate with the shortened
socket wrench (5 mm Allen socket).
The traverse must lie against the end stop.
9. Make sure the end stop rail guide catches on the traverse
correctly.
10.Use the socket wrench (2 mm Allen socket) to screw down the
cable carrier mount.
Maintenance
Exchanging the AXI transport belts
219
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
11.Connect the motor cable to the motor coupling.
12.Set the connector and the cable into the clips.
13.Bind the cable with cable ties.
14.Use the socket wrench (4 mm Allen socket) to install the hold-
down clamp.
15.Repeat steps 1 to 14 for the transport belt on the fixed trans-
port side plate.
16.Place a PCB in the transport track and check whether the end
stop guide rails of the movable and the fixed transport side
plates are parallel to each other.
The transport belts are installed.
The AXI transport belts are exchanged.