X7056_Operating manual_en.pdf - 第238页
Decommissi oning Take the inspection system out of operation 238 Inspection system X7056 | Operating manual | Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
Decommissioning
Take the inspection system out of operation
237
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
Securing the power supply cables
There are power supply cables on the front and back sides of the
inspection system. Secure these cables so they are not damaged.
ATTENTION
Damage to the inspection system
There are power supply cables on the front and back sides of the
inspection system.
Make sure that no cables are underneath the system.
Perform the following work steps:
Tie up all cables beneath the inspection system with cable ties.
The power supply cables are secured.
Cleaning the Inspection System
Perform the following work steps:
1. Open the front door and the rear swing doors.
2. Clean the interior of the system with a dry cleaning cloth.
3. Vacuum the interior of the system.
The inspection system is cleaned.
Decommissioning
Take the inspection system out of operation
238
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
Packing 239
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
Packing
This chapter describes how to pack the inspection system, step by
step.
It contains the following sections:
Safety (Page 240)
Packing the inspection system (Page 241)
Storage (Page 249)
Disposal (Page 250)