X7056_Operating manual_en.pdf - 第250页
Packing Disposal 250 Inspection system X7056 | Operating manual | Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a Disposal Disposal of the inspection system must be done according to the regulations of the land the system…
Packing
Storage
249
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
Storage
For storage, it is important to ensure that the inspection system
and its accessories are protected from potential damage.
NOTE
Always store the system in its original packaging until it is installed
and observe the storage requirements.
Ensure appropriate protection to prevent damage due to the
following factors:
Rain, humidity
Temperature fluctuations that may cause condensation
Dust
Aggressive and soiling environments which may lead to corro-
sion
Mechanical damage or unauthorized opening of the packaging
Strong vibration (loosening of attached parts, fatigue damage,
etc.)
If the X-ray tube is not used for a longer time, a warmup
procedure has to be performed at least every 3 months to
guarantee function, see „Maintenance“ > „Warm-up procedure“
(Page 220).
Storage conditions
Permissible weight load for the
ground surface
950kg/m
2
Permissible weight load for the
ground surface (per system foot)
39 N/cm
2
Ambient temperature 0°C to 70°C
Humidity to 80%, not condensed
Average humidity <60 %
Packing
Disposal
250
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
Disposal
Disposal of the inspection system must be done according to the
regulations of the land the system is installed in.
Beryllium waste (sealed X-ray tube) must be disposed off as
hazardous waste in special and sealed containers.
It is possible to allow the Viscom AG to properly dispose of the
system. The customer bears the cost of transporting the system to
Viscom.
The Viscom AG observes the regulations established by RoHS-
Directive 2002/95/EC.
Technical specifications 251
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
Technical specifications
This chapter provides all the important technical data for the
inspection system.
It contains the following technical specifications:
System specifications (Page 252)
Environmental conditions (Page 253)
XM camera technology (Page 254)
Sealed X-ray tube (Page 255)
Flat panel detector (Page 256)
Transport system (Page 257)
System Dimensions (Page 258)
Center of Mass (Page 260)
Tipping Angle (Page 261)
System weight (Page 263)