00196849-02 OG SIPLACE Operation of X and SX-Series without SSC (SW70x) - 第132页
Refilling Component Reels - Splic ing - Required Tools and Mater ials : 132 Splicing - Required Tools an d Materi als These tools and ma terials ar e re quired for tape splicing. 1. Adhesive t ape (small) 2. Tweez ers 3.…
Refilling Component Reels - Checking the Component Reels :
131
Refilling Component Reels
1. Continuously check the component reels to see if
they are running out – if there is around 1m of
component tape left then it is time to splice a new
reel!
2. Obtain a new reel of components from the storage
location.
3. Compare the new reel's label with that of the old reel.
4. Wind the remaining tape off the old reel.
WARNING! Ensure that the part numbers of the
old and new reels are the same!
Refilling Component Reels - Splicing - Required Tools and Materials :
132
Splicing - Required Tools and Materials
These tools and materials are required for tape splicing.
1. Adhesive tape (small)
2. Tweezers
3. Scissors
4. Splicing rivets
5. Splicing tool
6. Adhesive tape (large)
Refilling Component Reels - Preparation of carrier tape end :
133
Preparati on of carrier tape end
Carrier tape end:
1. Carrier tape end is protruding from the feeder
2. Cut carrier tape exactly between two pockets in the
middle of the hole, as shown in picture. All pockets
must be full to end of carrier tape
Note: Carrier tape splicing must occur with enough lead
tape length to prevent the machine to be stopped.