192277 - Micron Technical Reference Volume 3 - 第178页
PASTE ROLL HEIGHT MONITOR ADJUSTMENTS & SETTINGS 30.10 Technical Reference Manual Chapter Issue 3, Aug 14 8. Set each arm to provide a gap be tween the edge of the squeegee (or deflector) equal to 10mm . 9. Close the…
PASTE ROLL HEIGHT MONITOR
ADJUSTMENTS & SETTINGS
Chapter Issue 3, Aug 14 Technical Reference Manual 30.9
24. Press the System button.
25. Select Exit.
Beam Width
Adjustment
The width of the beam is set to accommodate the front squeegee and the
product.
1. Select Diagnostics.
2. Using the Next or Previous buttons; select Print Carriage.
3. Select Home Print Carriage.
4. Select Drive Carriage to Front Position.
5. Select Exit.
6. Open the printhead front cover.
7. The beam width adjustment screws are located as shown below.
Paste Height Adjustment
Securing Screw
(in 2 positions)
THK Linear Bearing
(in 2 positions)
Width Adjustment Securing Screw
(in 2 positions)
Front Squeegee
Mount
Horizontal Beam
PASTE ROLL HEIGHT MONITOR
ADJUSTMENTS & SETTINGS
30.10 Technical Reference Manual Chapter Issue 3, Aug 14
8. Set each arm to provide a gap between the edge of the squeegee (or
deflector) equal to 10mm.
9. Close the front printhead cover.
10. Press the System button.
11. Select Exit.
Roll Height Monitor
Width Adjustment
Securing Screw
(in 2 positions)
10mm 10mm
Front Squeegee
PASTE ROLL HEIGHT MONITOR
REPLACEMENT PROCEDURES
Chapter Issue 3, Aug 14 Technical Reference Manual 30.11
REPLACEMENT PROCEDURES
Fitment Carry out the following procedure to fit the Roll Height Monitor to the machine:
1. Ensure the machine is powered down.
2. Release the front squeegee thumbscrews and remove the front squeegee.
3. Remove the Squeegee ‘I‘Beam, use the three mounting screws for fitting the
roll height monitor.
4. Fit the roll height monitor assembly to the front squeegee mounting plate
and secure with the three screws.
5. Connect the electrical connector 9PL60 to 9SK60.
6. Fit the front squeegee to the roll height monitor assembly.
Front Squeegee
Leadscrew
Roll Height Monitor
Width Adjustment
Securing Screw
(in 2 positions)
Front Squeegee Mount
‘I’ Beam Securing Screws
(in 3 positions)
Electrical Connector 9PL60
to Print Carriage IO Node 3