M7_ServiceManual_e.pdf - 第14页

1 Installation 1-6 ACTION: ① Locate the mounter to the specified place. ② Remove the followings: the b olt, metal fittings, and the nylon ties that fasten Beams that prevent to move during transporta tion. Check to see t…

1 Installation

1-5

Installing the Mounter

Do not touch terminals of electric components when the power is on to prevent electric shock and machine

damage.

Make sure to ground the mounter to prevent electric shock.

Note on Installation

It is normal that the adjust foot can be slightly inclined (within 2-degree range).

Do not tighten the bolt forcedly trying to fix the foot.

When you move and/or install the mounter, be careful not to apply excessive

force on the adjust foot. This may cause the screw of the adjust foot to break.

When placing the mounter on the floor, be sure that the mounter is kept

horizontal.

Warning

2°

If excessive force is

applied, the screw may

break at this point.

Mounting Screw

Nut

Adjust foot

1 Installation

1-6

ACTION:

① Locate the mounter to the specified place.

② Remove the followings: the bolt, metal fittings, and the nylon ties that fasten Beams that prevent to

move during transportation. Check to see that the X beams and heads can move to the Y direction

manually.

NOTE: Keep the removed metal fittings in case of moving the mounter for future reinstallation.

Nylon ties (Rear side)

Rear of the center beam

Metal fitting

on each head

Nylon tie (Front side)

Both at the left and right sides

The warning tag with “Remove

this.”

Only the center beam of M7-3S/3L is

fixed at the rear side

1 Installation

1-7

③ When the mounter is installed stand alone, turn the adjust feet so that the PCB transfer height is the

same as the conveyor height (900±20mm (see Note)) of the reference equipment. In the case of

SMEMA interface spec, the height must be 950±20mm.

④ When the mounter is connected to the Pre-process on production line, adjust the PCB transfer height

to the conveyor rail height of the Pre-process.

)

Production Line

NOTE: The height must be 890 to 920mm in the case of CFB wagon spec.

NOTE: The adjust feet must be turned using a M30 single-head wrench (nominal: 46mm).

⑤ Place a level on the base of the mounter. Set the position to the conveyor of the Pre-process finely until

the mounter is leveled.

) Supplementary Explanation for Installation

900±20mm

950±20mm (SMEMA)

Level