M7_ServiceManual_e.pdf - 第21页

1 Installation 1-13 Power Cable Wiring Route the power cable to outsi de the mounter t hrough the rectangle cable hole at t he lower part of the rear cover. (See Fig. 1 and 2.) The power cable should be secured inside th…

1 Installation

1-12

A A

M7-3S

Bottom face of Jack-up Points A.

Bottom face of Jack-up points B.

NOTE: The hydraulic jacks must satisfy the following requirements.

Allowable load: 1.5 tons or higher

Hook size: 100mm or more (stroke)

Part Name

Part No. Remark

PLATE,BASE LG0-M8911-00X For plates 1 and 2

GOM,BASE LG0-M8912-00X Base rubber

190 190

310

Front Side

Rear Side

19300

Jack-up point

Two each at front and rear

Jack-up point

Two each at front and rear

1 Installation

1-13

Power Cable Wiring

Route the power cable to outside the mounter through the rectangle cable hole at the lower part of the rear

cover. (See Fig. 1 and 2.)

The power cable should be secured inside the mounter to prevent accidental disconnection by pulling on the

cable outside the mounter.

To fasten the power cable with cable ties, first attach cable clamps to unused screw holes then insert cable

ties through the cable clamps. Or bind the power cable to the terminal-panel leg with cable tie. (See Fig.3

and 4.)

Recommended cable: 3.5mm

, withstanding voltage 600V (VCT or equivalent)

Cable stripping length: 12mm length

Cable clamp Power cable Cable hole at the bottom of the rear cover

Fig.1

Fig.2

Fasten the power cable using a cable

clamp and a cable tie.

Fig.3

Fig.4

Bind the power cable to the

terminal-board leg with cable ties.

1 Installation

1-14

Removal of Rust Inhibiting Grease

At packing and shipping, a large amount of grease is applied on the surface of each ball-screw and linear

guides on Y-axis in order to prevent rust. As each axis moves an excess grease is gradually removed from

their surface and a proper amount of grease remains as a lubricant.

For this reason, when these axes are moved at installation, the extra grease may be built up on ball-screw

nuts, on linear guide sliders, and both ends of each axis. If you run the mounter at high speed (production)

without wiping it away, the grease may be scattered around due to centrifugal force and vibration, and that

may stick to cameras, sensors, or a board.

Please perform a warm-up at low speed once the origin is acquired after installation, and wipe off any

excess grease as necessary.

The mounter may not function properly when grease sticks to the sensors

and the cameras.

ACTION:

① Check and remove any board and tools from inside of the mounter, and then perform origin

acquisition.

② Select Main Menu> Manual> Warm Up.

③ Select Warm-up & Self-diagnostics> Setting.

④ Select [XY-axes] and set up the parameters as follows.