M7_ServiceManual_e.pdf - 第23页

1 Installation 1-15 ***** This function is not ready for now . ***** ⑤ Uncheck all the item s other than the [XY-axes] tab. Uncheck al l the item s in [Conveyer], [Head], [Board Clamp], [ANS], [Feeder Bank], and [Lam p &…

1 Installation

1-14

Removal of Rust Inhibiting Grease

At packing and shipping, a large amount of grease is applied on the surface of each ball-screw and linear

guides on Y-axis in order to prevent rust. As each axis moves an excess grease is gradually removed from

their surface and a proper amount of grease remains as a lubricant.

For this reason, when these axes are moved at installation, the extra grease may be built up on ball-screw

nuts, on linear guide sliders, and both ends of each axis. If you run the mounter at high speed (production)

without wiping it away, the grease may be scattered around due to centrifugal force and vibration, and that

may stick to cameras, sensors, or a board.

Please perform a warm-up at low speed once the origin is acquired after installation, and wipe off any

excess grease as necessary.

The mounter may not function properly when grease sticks to the sensors

and the cameras.

ACTION:

① Check and remove any board and tools from inside of the mounter, and then perform origin

acquisition.

② Select Main Menu> Manual> Warm Up.

③ Select Warm-up & Self-diagnostics> Setting.

④ Select [XY-axes] and set up the parameters as follows.

1 Installation

1-15

***** This function is not ready for now. *****

⑤ Uncheck all the items other than the [XY-axes] tab. Uncheck all the items in [Conveyer], [Head],

[Board Clamp], [ANS], [Feeder Bank], and [Lamp & Buzzer] tabs (tabs may vary due to mounter’s

option ) in order to carry out only the selected items in the [XY-axes] tab.

⑥ Select the upper [Execute] tab and click <Ageing>.

When [Execute] tab is selected, the <Execute> button and the<Ageing> button are Shown at the

bottom of the window. Click <Ageing>.Clicking the <Execute> button enables to perform warm-up

only a single cycle and sufficient ageing is not carried out.

1: Check the “Execute Warm-up of

XY-axes” box.

2: Move the scroll bar and set

“Axis Speed” at 10%.

3: Check the “XY” box for the item

“Axis”.

4: Check the “Entire Area Check“ box

for the item “Range”.

NOTE: It is not necessary to check

box for the other items.

３

１

２

４

1 Installation

1-16

⑦ Continue ageing for 5 to 10 minutes.

After 5 to 10 minutes, click the <Stop> button to stop ageing.

⑧ Wipe off excess grease.

Use a unwoven cloth to wipe off excess grease which is built up on ball-screw nuts, on linear guide

sliders, and both ends of each axis.

NOTE: Refer to Chapter 3 Mechanical Section for the location of each axis.

⑨ Check to be sure that the excess grease has not been scattered around.

Make sure the excess grease has not been stuck on sensors, cameras, conveyer and its belts, and ANC

When it has been stuck on these parts, remove it with unwoven cloth.

NOTE: Refer to Chapter 3 mechanical Section for more detail in cleaning of scan camera and mirror.

Ageing Button

Execute Tab