AX501最新3.6x版英文操作手册 - 第37页

4022 593 51894 Operatin g Man ual 09.01 AX-301/501, AX-3/5 37 9 CHAPTER 9 Pr oduction In case of an err or , see chapter 1 0 . E r ror H and l ing . 9.1 Start pr oduction Figure 46 Start production To s t a r t p r o d u…

100%1 / 47
4022 593 51894 Operating Manual
09.01 AX-301/501, AX-3/5 36
8
8.6 Toolbit check
Check if the toolbits, needed for production, are available in the toolbit
exchange unit.
1 Place the missing toolbit(s).
NOTE: Use, when necessary, the stepstool to prevent an unsafe
work load.
Figure 44 Placing a toolbit in the toolbit exchange unit
2 Close the run-in and run-out covers and lower the robots.
3 Place the feeder trolleys.
Figure 45 Placing the feeder trolleys
4022 593 51894 Operating Manual
09.01 AX-301/501, AX-3/5 37
9
CHAPTER 9 Production
In case of an error, see chapter 10. Error Handling.
9.1 Start production
Figure 46 Start production
To start production:
• Select ’Operation’ button (1).
• Select ’Start’ button (2).
If no error message appears, the machine starts production.
If an error message does appear, see chapter 10. Error Handling.
9.2 Maintain production
9.2.1 Tape splicing
See Appendix.
9.2.2 Tape cutting on the feeders
Cut and remove carrier tape and top foil regularly.
Figure 47 Tape cutting
1
2
"
4022 593 51894 Operating Manual
09.01 AX-301/501, AX-3/5 38
9
9.2.3 Monitor and improve machine performance
Figure 48 Monitor and improve machine performance
To monitor and improve the performance, select the tabs (1). For more
information, see the following paragraphs.
9.2.3.1 'Pick & Align'
'Pick & Align', that shows where to improve.
Improve the shown 'Trolley-feeder-lane' combinations to achieve the
biggest PPM improvement on machine level.
To show the improve mode:
1Select 'History'
2 Select 'Pick & Align'
3 Set parameters:
• ‘Improve’ mode
• ‘All’ feeders
• ‘All’ components
• ‘2 hours’ period
• ‘Pick + Align’ error type
• ‘Manual + Auto’ retry type
Figure 49
4 Monitor the machine PPM level: is it above specification?
a No: do not take any action (chances are that the PPM level gets
worse after action).
b Yes: improve the shown 'Robot-feeder-lane' combinations with
highest percentages.
5 After making improvements: select 'Reset'.
Enter a description of the improvement actions (can later be
1
1
2
4
5
3
4b