SG_FSE_SiplaceHF_HF3_00193901-05_eng - 第334页

1 - 22 S tudent Guide SIPLACE HF/HF3 7 TWIN-Head Edition 09/2005 22 7.4.1.3 CAN Processorboard 16 Bit The 16 BIT CAN Processo r is used for different functions of the following units: – Visionboard, Communication and con…

1 - 21

Student Guide SIPLACE HF/HF3

Edition 09/2005 7 TWIN-Head

7.4.1.2 Vision board

The vision board is connect on the top of the head interface. That board is also used on the

gantry 1 with a C&P head.

Fig. 7.4 - 2 Vision board

1. Connector illumination PCB camera

2. Connector video signals PCB camera

3. LED‘s P15V - 15Volt / Vcc - Power supply Vision board

4. DIP Switch

5. CAN Processor 16 Bit (additional board on the Visionboard)

6. DC/DC Converter 15 --> 5V for Visionsystem

Please Note:

The DIP Switch configuration for the gantry configuration is decribed in chapter gantry .

1 - 22

Student Guide SIPLACE HF/HF3

7 TWIN-Head Edition 09/2005

7.4.1.3 CAN Processorboard 16 Bit

The 16 BIT CAN Processor is used for different functions of the following units:

– Visionboard, Communication and control via the ICOS system

– Mainboard Twin head, control the Vacuum generator

– Visionboard for the stationary IC (FC) - Camera, communication and control via the ICOS

system

Abb. 7.4 - 3 16 Bit Processor

Description 7 Segment display ( Standard mode " . " flashed):

– After switch ON the machine " 0 " appears on the display

– Display " b " Bios is started.

– Display flash alternately "b" and " . " --> none Application available or can not started.

– Display " -I " und " I- " Application is loaded and now starts.

– The " . " on the display flashed.

(1) 7 Segment display

(2) LED red at the bei manual RESET

on the Processors

(3) 16 Bit Processor

1 - 23

Student Guide SIPLACE HF/HF3

Edition 09/2005 7 TWIN-Head

7.4.1.4 Head adapter Twin Head

The head adapter board connects the head interface board directly to the main board of Twin head

segment 1 and 2 via ribbon cable. This head adapter must be changed for head modularity, if you

use a C&P head.

Fig. 7.4 - 4 Head adapter Twin head

Please Note:

The ribbon cable sets for the Twin head segment 1and 2 are different.

(1) Connector Z-Axis Twin head 1 (2) Connector D-Axis Twin head 1

(3) Connector DP-Axis Twin head 2 (4) Connector Z-Axis Twin head 2

(5) PP1 Boot CAN Processor Twin Segm. 1 (6) PP1 Reset CAN Processor Twin Segm. 1

(7) PP2 Boot CAN Processor Twin Segm. 2 (8) PP2 Reset CAN Processor Twin Segm. 2

OFF