SG_FSE_SiplaceHF_HF3_00193901-05_eng - 第49页
1 - 23 S tudent Guide SIPLACE HF/HF3 Edition 09/2005 2 Overview 23 2.2.8.3 Overview T ape feeders Description: Only 9 diff erent feeder sizes are needed to feed tapes from 8 mm to 88 mm. Reels are kept in the t ape cont …
1 - 22
Student Guide SIPLACE HF/HF3
2 Overview Edition 09/2005
22
2.2.8.2 Adjust the changeover table height
The COT can be prepared for the following PCB transportation heights by hand.
– 830 mm ± 15 mm Standard-height
– 900 mm ± 15 mm SMEMA-height
– 930 mm ± 15 mm SMEMA-height
– 950 mm ± 15 mm SMEMA-height
Fig. 2.2 - 12 COT with Transport height 950 mm
(1) Pins for showing the height (2) Upper part of the COT
(3) trolley (bottom part )of COT (4) here height adjustment of COT version ’A’
All height marking pins disappear at the standard transportation height of 830 mm under the side
of the upper part of the COT .If the upper part of the COT is lifted, the marking pins will be press
out by a spring. The upper part of the COT lain on these marking pins.
4
1 - 23
Student Guide SIPLACE HF/HF3
Edition 09/2005 2 Overview
23
2.2.8.3 Overview Tape feeders
Description: Only 9 different feeder sizes are needed to feed tapes from 8 mm to 88 mm. Reels
are kept in the tape container on the component changeover table. The table cutter automatically
cuts the used tape. SIPLACE feeders have short cycle times and highprecision pick-up positions.
The feeders can also be used in other SIPLACE placement machines.
Bulk case feeders, vibratory stick feeders, surftape feeders, dip flux modules, component return
modules, and manual trays may be set up in addition to the tape feeders. Dummy feeders are
used at unassigned locations to protect the operators.
Fig. 2.2 - 13 Overview feeders
1 - 24
Student Guide SIPLACE HF/HF3
2 Overview Edition 09/2005
24
2.2.9 Position of the gantrys
Fig. 2.2 - 14 Position of the gantries HF3
Legend:
Please Note
The HF machine have only two gantries. The name of this Gantries with Stationsoftware
505.xx is Gantry 1 and Gantry 3.
G1Gantry 1 G3Gantry 3
X1X-Axis, Gantry 1 X3X-Axis, Gantry 3
Y1Y-Axis, Gantry 1 Y3Y-Axis, Gantry 3
G4Gantry 4
X4X-Axis, Gantry 4 (T)Transport direction
Y4Y-Axis, Gantry 4
G4
G1
G3
Y4
Y3
Y1
X4
X3
X1
T