CM602all_EJM8AESM_Service Manual - 第1039页
Move the extension-axis towards you 382.5 mm. Tray Direct Tray Remark How to position the jig. (right picture) Jig: FM-1924 turned by hand. Remove the jig. Torque wrench 9.8N•m Allen key 4 mm Screw M5 4 pcs. Allen key 2.…
Put the palette table back on with the
four Hexagon bolts.
Return the extension-axis to the origin.
Allen key 2 mm
Phillips screwdriver #1
M3 6 pcs.
Truss 6 pcs.
Direct Tray
Item Remark
Tray
9
Allen key 4 mm
Screw M5 4 pcs.
Turn on the power.
10
11
12
TP-axis
Screw M5×40
Allen key
EJM8A-E-SMA070208-A01-00
Page 7-2-8-4
Move the extension-axis towards you 382.5 mm.
Tray Direct Tray
Remark
How to position the jig. (right picture)
Jig: FM-1924
turned by hand. Remove the jig.
Torque wrench 9.8N•m
Allen key 4 mm
Screw M5 4 pcs.
Allen key 2.5 mm
Screw M3 2 pcs.
After tightening, the bearing should be
13
Position the bearing with the jig.
14
Tighten the power locks at the motor section
with a torque wrench. TIghtening torque:
9.8N•m
16
Item
15
The dowel pin of the jig should be inside the LM, and
the hollow of the rear of the jig should on the LM.
Position the dog slit at the extension
position. Inch the axis with a pitch of 0.1
mm.
436.5
A=382.5mm
Origin position
E
C
D
(392.5)
6
F
Magazine
(2)
(51)
B=9
Supply
section
Magazine side
(0.5 mm)
Lift side
(1.0 mm)
Optical-axis sensor
Extension position PH sensor
PH632( 32)
Dog
Light through: ON
Light blocked: OFF
Light blocked at mechanical stopper on negative direction.
Supply section
EJM8A-E-SMA070208-A01-00
Page 7-2-8-5
the bolt shown with the arrow below.
Phillips screwdriver #2
Screw M4 11 pcs.
Carry out pickup position teaching.
Position the magazine stopper.
See the followings:
Section 7-2-2 Direct Tray
Pickup Position Teaching
Section 7-2-3 Magazine
Shutter Stopper Position
Adjustment
Tray
Phillips screwdriver #2
Screw M4 4 to 6 pcs.
19
Direct Tray
Item Remark
Rear
Right
17
18
Close the cover.
Left. Stay at the front side when tightening
Put the cover back on.
EJM8A-E-SMA070208-A01-00
Page 7-2-8-6