CM602all_EJM8AESM_Service Manual - 第1052页
Jig: FM-1924 Pulley-holding jig Tension gauge Phillip screwdriver #2 Allen key 2 mm Allen key 3 mm Allen key 4 mm Pulley remover Tension gauge Torque wrench Teaching Direct Tray • This section describes the procedures fo…
Another parameter
2
Name
PF18 For manufacturer setting
PF19 For manufacturer setting
PF20 For manufacturer setting
Another parameter
3
Name
For manufacturer setting
For manufacturer setting
For manufacturer setting
For manufacturer setting
For manufacturer setting
TL-axis TP-axis
Direct Tray
Lift-axis (TL) and Extension-axis (TP) Parameter List
No.
PO04
PO05
PO06
PO07
TL-axis
0
Tray
PO01
PO02
For manufacturer setting
0
0
0
No.
PO03
0
0
0
0
PO08
Option card mount detection
For manufacturer setting
0
0
0
0
0
0
0
0
0
0
TP-axis
0
0
0
0
EJM8A-E-SMA070209-A01-00
Page 7-2-9-11
Jig: FM-1924
Pulley-holding jig
Tension gauge
Phillip screwdriver #2
Allen key 2 mm
Allen key 3 mm
Allen key 4 mm
Pulley remover
Tension gauge
Torque wrench
Teaching
Direct Tray
• This section describes the procedures for replacing the extension-axis motor.
7-2-10 Extension-axis Motor Replacement
Min.
30
Removal/Disassembly
20
Min.
kgs.
80
Part Weight
Assembly/Adjustment
Min.
Total
Min.
30
Tray
Tool
Jig
Caution
Danger
Warning
EJM8A-E-SMA070210-A01-00
Page 7-2-10-1
the bolt shown with the arrow below.
3
4
Rea
r
2
Direct Tray
Remark
Allen key 2 mm
Phillips screwdriver #1
M3 6 pcs.
Truss 6 pcs.
Phillips screwdriver #2
Screw M4 4 to 6 pcs.
Phillips screwdriver #2
Screw M4 11 pcs.
Open the cover.
RightLeft. Stay at the front side when removing
Turn off the power.
Remove the bolt.
Remove the tray from the machine.
Item
Tray
Remove the motor connectors ENTP2
(4) and TPM2 (4).
1
Remove the four Hexagon bolts, and then
the palette table. Be careful not to drop the
bolts.
Remove the cover.
TP-
axis
EJM8A-E-SMA070210-A01-00
Page 7-2-10-2