CM602all_EJM8AESM_Service Manual - 第144页
Maintenance Adjustment Main Body Beam ・ Tools Phillips screwdriver #2 Allen key 2.5 mm Allen key 3 mm Caliper 500 mm Ruler 500 mm ・ Jig None This section describes the procedures for adjusting the original width of the b…
Maintenance Adjustment Main Body Beam
Remarks
Item
Tighten the theta holding set screws.
Allen key 1.5 mm
Teach "Board Recognition Camera - X and Y-axis Origin Offset."
For details, see Sections at right. High-speed machine:
Section 4-2-2
Multi-purpose machine:
Section 4-3-2
Specifications:
within +/- 0.05°
Put back the feeder cover.
Phillips screwdriver #2
Screw M4 2 pcs.
15
14
13
Lightly
tighten
Lock
No
screw
ON
EJM8A-E-SMA040102-A01-00
Page 4-1-2-5
Maintenance Adjustment Main Body Beam
・Tools
Phillips screwdriver #2
Allen key 2.5 mm
Allen key 3 mm
Caliper 500 mm
Ruler 500 mm
・Jig
None
This section describes the procedures for adjusting the original width of the board transfer conveyor.
Remove the support pins beforehand.
4-1-3 Adjusting the Original Width of the Board Transfer Conveyor
Assembly
Adjustment
10min.
Teaching
min.
Total Time Weight of
Part
Removal
Disassembly
10min.
20min.
kgs
Caution
Dange
r
Warning
EJM8A-E-SMA040103-A01-00
Page 4-1-3-1
Maintenance Adjustment Main Body Beam
Remarks
Set the conveyor width to 460 mm.
Enter 460 into the [W] box and press [Run]
so that the conveyor width becomes 460.5 mm automatically.
Check the width with calipers.
Specifications:
460.5 mm+0 mm to
0.2mm
(460.5 mm to 460.7 mm)
Remove the feeder cover and the chute.
Phillips screwdriver #2
Allen key 3 mm
Screw M4 2 pcs.
Screw M4-10 3 pcs.
Thick washer 3 pcs.
If the width is out of the specification, change the position of the width-adjusting origin sensor.
Allen key 2.5 mm
Screw M3 2 pcs.
Item
Remove the three screws below. Pull up the chute and remove it.
3
4
1
2
Sensor
Dog
Loosen the two
screws and
adjust the sensor
position.
460.5 mm
EJM8A-E-SMA040103-A01-00
Page 4-1-3-2