CM602all_EJM8AESM_Service Manual - 第168页
If the value is out of the offset range, follow Steps 5 to 12. Maintenance Adjustment Select [Lead checker] from the Remove the feeder cover. Remove the cutter chute cover. 3 1 Main Body Beam Remarks For details, refer t…
Weigh
t
o
f
Part
20 min. min.
Removal
Disassembly
A
ssembl
y
Adjustment
Teaching
Total Time
20 min.20
min
.
60
Kgs
.
Main Body BeamMaintenance Adjustment
Phillips screwdriver #2
Allen key 4 mm
Wrench 7 mm
4-1-9 Lead Checker Height Adjustment
・Tools
This section describes the procedures for adjusting the height of the lead checker.
FM-1137
Laser Recognition Jig
・Jig
Caution
Danger
Warning
EJM8A-E-SMA040109-A01-00
Page 4-1-9-1
If the value is out of the offset
range, follow Steps 5 to 12.
Maintenance Adjustment
Select [Lead checker] from the
Remove the feeder cover.
Remove the cutter chute cover.
3
1
Main Body Beam
Remarks
For details, refer to
"Section 4-3-11 Lead
Checker"
Tools and Specifications
Perform "Z teach" only.
Tools and Specifications
Phillips screwdriver #2
Screw M4 2 pcs.
Offset range:
Z: -1.0 mm to +1.0 mm
Allen key 3 mm
Screw M4 3 pcs.
Tools and Specifications
Tools and Specifications
2
"Machine parameter teach" screen.
4
Item
Check the value for "Z teach."
EJM8A-E-SMA040109-A01-00
Page 4-1-9-2
Adjust the height so that the value in [Z]
becomes 0 as nearly as possible.
When tightening the screws,
be careful that the Z value remains
within the range.
Loosen the adjusting bolt holding nut.
5
Main Body Beam
Item
Allen key 4 mm
Screw M5 2 pcs.
Loosen the bracket holding screws.
6
Maintenance Adjustment
Tools and Specifications
Do not remove them; just loose.
Tools and Specifications
Tools and Specifications
Remarks
8
7
Basic height:
Adjust the height.
Once the adjustment has been completed
tighten the bracket holding screws.
Tools and Specifications
Wrench 7 mm
Nut 7 mm
Allen key 4 mm
Screw M5 2 pcs.
Laser Emitting
section
8.0mm+/-0.5mm
Laser Recognition Jig
Holding bracket
≒13.5mm
Holding bracket
EJM8A-E-SMA040109-A01-00
Page 4-1-9-3