CM602all_EJM8AESM_Service Manual - 第299页
Maintenance Adjustment Light Transfer-Head Assembly (3 nozzles) Remarks Initial setup Connect the power supply cord to the feeder connector. Set "Input range." 1 2 3 Item ① Escape: used to return to the previou…
Maintenance Adjustment Light Transfer-Head Assembly (3 nozzles)
This section describes the procedures for determining offsets for the load applied to the load head.
・Tools
None
・Jig
Nozzle 1003
Load Measuring Jig
作業時間 15分
部品重量 - kg
4-3-10 Load Head
Caution
Danger
Warning
Assembly/Adjustment
20 min.
Teaching
15 min.
Removal/Disassembly
min.
Total Time
35 min.
Part Weight
kgs.
EJM8A-E-SMA040310-A01-00
Page4-3-10-1
Maintenance Adjustment Light Transfer-Head Assembly (3 nozzles)
Remarks
Initial setup
Connect the power supply cord to the feeder connector.
Set "Input range."
1
2
3
Item
①Escape: used to return to the previous operation.
②Mode: used to change menu or to determine the set value.
③Up: used to change setting.
④Shift: used to shift the highlight to the right digit when setting.
⑤RESET/TEACH: used to reset or to teach.
①②
③④ ⑤
ESC
RESET/
TEACH
Press several times until
"SETUP" is displayed.
Power up and press for 1 sec.
Press for 1 sec.
Press to highlight the digit
to be changed.
To display "b LC," press
To determine, press
ESC
and
EJM8A-E-SMA040310-A01-00
Page4-3-10-2
Maintenance Adjustment Light Transfer-Head Assembly (3 nozzles)
Remarks
Item
Press [Load Head].
The board width is set to 70 mm and the
conveyor width is adjusted automatically.
Press the "Unlock" key and [Jig setting]
Place the load cell jig.
simultaneously. The cable should not be
higher than the height of
the load cell.
Setting Input value 2.
4
5
6
Press several times until the
"SCALE" is displayed.
Press for 1 sec.
RESET/
TEACH
Place a 1-kg weight on the load cell.
Press for 1 sec.
RESET/
TEACH
Press again.
To determine, press
EJM8A-E-SMA040310-A01-00
Page4-3-10-3