CM602all_EJM8AESM_Service Manual - 第385页

Pull out the support table. ・ Be careful not to damage the cylinder joint and the dog, which are moved in Step 8. ・ Do not loosen the table shaft. parallelism of the table will become out. Tools and Specifications Replac…

100%1 / 1093
Do not remove the bars.
Tools and Specifications
12
Allen key 5 mm
Screw M3 6 pcs.
Remove the screws holding the support-
unit upper-limit determining bars.
11
Insert a 15-mm-thick bar behind the support-unit upper-limit determining bars.
Tools and Specifications
15-mm-thick metal bar
(160 mm to 200 mm)
2 pcs.
Tools and Specifications
Remark
100-mm block
or equivalent
Raising the sub plate by hand, insert a 100-mm block or equivalent.
Allen key 2.5 mm
Screw M3 6 pcs.
Tools and Specifications
10
Block:
should be enough to support the sub
plate.
Move the sensor outwards.
9
Machinery Part Replacement Board Holder Unit
Item
Ex
EJM8A-E-SMA050201-A01-00
Page　5-2-1-4
Pull out the support table. ・Be careful not to damage the cylinder
joint
and the dog, which are moved in Step 8.
・Do not loosen the table shaft.
parallelism of the table will become out.
Tools and Specifications
Replace the cylinder. ・Do not loosen the shaft. Otherwise
Wrench 30 mm
Box wrench 30 mm
13
Remove the block.
Tools and Specifications
Lower the sub plate.
Tools and Specifications
holding screws.
Allen key 5 mm
Screw M6 4 pcs.
16
Remove the cylinder holding nut.
14
Remove the support-plate cylinder
15
Tools and Specifications
・
Be careful of interference of the sensor
Item Remark
Machinery Part Replacement Board Holder Unit
Shafts
EJM8A-E-SMA050201-A01-00
Page　5-2-1-5
joint.
and the dog, which are moved in Step 8.
100-mm block or
equivalent
Item Remark
Machinery Part Replacement Board Holder Unit
17
Place the support table in the machine.
Tools and Specifications
・Be careful not to damage the cylinder
・Be careful of interference of the sensor
18
Tighten the support plate cylinder
Allen key 5 mm
Screw M6 4 pcs.
19
Tools and Specifications
Raising the sub plate by hand, insert a 100-mm block or equivalent.
Tools and Specifications
holding screws.
Tools and Specifications
determining bars.
20
Position the support-plate upper-limit
Position so that the bar will
be in the center of the stopper.
Bar
EJM8A-E-SMA050201-A01-00
Page　5-2-1-6