CM602all_EJM8AESM_Service Manual - 第395页
Allen key 2.5 mm Screw M3 2 pcs. Place a new sensor in position. Put the cable back in the duct. Connect the connector. Tools and Specifications Tools and Specifications Allen key 2.5 mm Screw M3 2 pcs. Tools and Specifi…
Tools and Specifications
Tools and Specifications
Phillips screwdriver #2
Screw M4 2 pcs.
Remove the feeder cover
.
Switch off the main power and air supply.
Tools and Specifications
Tools and Specifications
Remove the connectors.
1
Item Remark
4
3
2
Pull the cable out of the duct.
Machinery Part Replacement Board Holder Unit
1
2
EJM8A-E-SMA050203-A01-00
Page 5-2-3-2
Allen key 2.5 mm
Screw M3 2 pcs.
Place a new sensor in position.
Put the cable back in the duct.
Connect the connector.
Tools and Specifications
Tools and Specifications
Allen key 2.5 mm
Screw M3 2 pcs.
Tools and Specifications
Machinery Part Replacement Board Holder Unit
RemarkItem
8
7
6
5
Remove the sensor.
Tools and Specifications
EJM8A-E-SMA050203-A01-00
Page 5-2-3-3
The sensor and the dog should not
interfere with each other.
Machinery Part Replacement Board Holder Unit
Item Remark
9
Switch on the main power.
Tools and Specifications
Tools and Specifications
Tools and Specifications
Phillips screwdriver #2
Screw M4 2 pcs.
Tools and Specifications
12
Supply air.
11
Put back the feeder cover.
10
Check the sensor position.
1
2
EJM8A-E-SMA050203-A01-00
Page 5-2-3-4