CM602all_EJM8AESM_Service Manual - 第401页
Machinery Part Replacement Board Holder Unit Remarks Item Remove the support-plate change plate. Remove the blocks, which were placed under the support-plate changed in Step 5. Connect the cylinder tubes. 3-000118,000119…
Machinery Part Replacement Board Holder Unit
Remarks
Item
Pull the cylinder down and remove it.
Lock the cylinder.
3-000114
Tighten the nut at the end of the cylinder.
3-000109
Gap from the top of the nut to the end of
the screw.
Wrench 12 mm
Calipers
Tighten the cylinder plate holding nut.
3-000107
Wrench 13 mm
11
12
10
9
㎜0.5
EJM8A-E-SMA050204-A01-00
Page 5-2-4-4
Machinery Part Replacement Board Holder Unit
Remarks
Item
Remove the support-plate change plate.
Remove the blocks, which were placed
under the support-plate changed in Step
5.
Connect the cylinder tubes.
3-000118,000119
Put the lower rear cover back on.
ｶﾊﾞｰ達
Phillips screwdriver #2
Round cross-head screw
6 mm 4 pcs.
Put back the rear chute.
ｶﾊﾞｰ達
Allen key 4 mm
Screw M5x12mm 4 pcs.
Thick washer 4 pcs.
13
14
15
16
Chute holding
section (left)
Chute holding
section (right)
EJM8A-E-SMA050204-A01-00
Page 5-2-4-5
Machinery Part Replacement Board Holder Unit
Remarks
Item
Switch on the main power and air supply.
ｶﾊﾞｰ達
From 0.49MPa
to 0.54MPa
17
1
2
EJM8A-E-SMA050204-A01-00
Page 5-2-4-6