CM602all_EJM8AESM_Service Manual - 第579页
Machinery Part Replacement This section describes the procedures for replacing the cutter blades. ・ Tools Phillips screwdriver #2 Allen key 3 mm Allen key 4 mm Feeler gauge ・ Jig None Cutting Unit Be very careful not to …
28
Switch on the power.
27
Put the feeder cover back on.
Phillips screwdriver #2
Screw M4 2 pcs.
26
Put the chute back on.
Allen key 3 mm
Screw M4 x 10mm 3 pcs.
Thick washer 3 pcs.
25
Put the feeder cover bracket back on.
Item Remarks
Feeder Cart Installing Section
Close the cover.
Tighten the left
and the right
screws.
EJM8A-E-SMA050802-A01-00
Page 5-8-2-8
Machinery Part Replacement
This section describes the procedures for replacing the cutter blades.
・Tools
Phillips screwdriver #2
Allen key 3 mm
Allen key 4 mm
Feeler gauge
・Jig
None
Cutting Unit
Be very careful not to get your hand cut.
5-9-1 Cutter Blade Replacement
Cuttin
g
Unit
5-9
Assembly
Adjustment
15min.
Teaching
min.
Total Time Weight of
Part
Removal
Disassembly
15min.
30min.
4kgs
Caution
Dange
r
Warning
EJM8A-E-SMA050901-A01-00
Page 5-9-1-1
Machinery Part Replacement
Remarks
Switch off the main power and air supply.
0.00MPa
Remove the feeder cover and the chute.
Phillips screwdriver #2
Allen key 3 mm
Screw M4 2 pcs.
Screw M4x10 3 pcs.
Thick washer 3 pcs.
Remove the top safety cover.
6-000102
Phillips screwdriver #2
Screw M4 5 pcs.
Remove the fixed cutter blade.
6-000118
Danger: Be careful not to get your hand
cut.
If the fixed cutter blade only is replaced,
proceed to Step 8.
Allen key 4 mm
Screw M5 9 pcs.
Cutting Unit
Item
2
3
4
1
1
2
EJM8A-E-SMA050901-A01-00
Page 5-9-1-2