CM602all_EJM8AESM_Service Manual - 第589页
Machinery Part Replacement ・ Tools Allen key 3 mm Allen key 4 mm Allen key 8 mm 7-mm wrench 24-mm wrench Calipers Shim ・ Jig None Cutting Unit 5-9-3 Fulcrum Bearing Replacement i This section describes the procedures for…
Machinery Part Replacement
Remarks
Cutting Unit
Item
Put the cylinder top cover back on.
Allen key 3 mm
Screw M4x8mm 5 pcs.
Put back the bottom cutter cover.
Allen key 3 mm
Screw M4x10mm 5 pcs.
Put the chute and the feeder cover back
Phillips screwdriver #2
Allen key 3 mm
Screw M4 2 pcs.
Screw M4x10mm 3 pcs.
Thick washer 3 pcs.
Open the cock of the MR unit.
From 0.49MPa
to 0.54MPa
24
21
22
23
1
2
EJM8A-E-SMA050902-A01-00
Page 5-9-2-7
Machinery Part Replacement
・Tools
Allen key 3 mm
Allen key 4 mm
Allen key 8 mm
7-mm wrench
24-mm wrench
Calipers
Shim
・Jig
None
Cutting Unit
5-9-3 Fulcrum Bearing Replacement
i
This section describes the procedures for replacing the fulcrum bearings.
Assembly
A
d
j
ustment
40min.
Teaching
min.
Total Time Weight of
Part
Removal
Disassembl
y
40min.
80min.
35kgs
Caution
Dange
r
Warning
EJM8A-E-SMA050903-A01-00
Page 5-9-3-1
Machinery Part Replacement
Remarks
Remove the cutter unit.
Refer to "Cutter Unit Replacement" Section 5-9-4
Wrench 7 mm
Spacer 1 pc.
Remove the fulcrum pin.
Wrench 24 mm
Allen key 8 mm
24-mm bolt pin 1 pc.
Screw M10 1 pc.
Replace the bearin
g
s.
Remove the top cover spacer close to the fulcrum pin.
3
4
2
Cutting Unit
1
Item
EJM8A-E-SMA050903-A01-00
Page 5-9-3-2