CM602all_EJM8AESM_Service Manual - 第705页
Press [Complete]. Press [Performance info]. Press [Reset]. Press [Run]. Press [Yes]. Press [Performance info]. Press [Pick Info]. Press [Error scrn]. Press [Reset]. Remarks Item 12-Nozzle Head Teaching Press [Next pick p…
Conveyor ref. side ...
Board stopper side ...
Movable conveyor ...
side
• Put one sheet of paper (plain paper) on the light box.
(To reduce light intensity)
• Put the light box on the stage to teach.
• Shadow recognition teaching: 110S
• Direct recognition teaching: 205S
• Shadow recognition teaching: Feeder change cart
Work: 1005R
Work-setting position: Left of the tape feeder
• Direct recognition teaching:
Work: 0603R
Work-settin
g
position: Ri
g
ht of the tape feeder
Tape feeder
Press [Production data teach].
Press [Pick pos learning].
Select the stage.
Remarks
5
Put the light box in the machine.
to the stopper. (Same pitch: Visual check)
Three pins: Press the light box against the above-
Machinery Part Replacement 12-Nozzle Head Teaching
• Put pins on the following positions, and put the light box in the machine.
mentioned pins and position pins along the box.
Three pins: One for next to each truss screw
(Opposite side of each truss screw to the stopper.)
Two pins: Vertical side of the plate corner close
Put an 8-mm-wide tape feeder on the number 7 position of each feeder change cart
.
(12 nozzles for each head, 48 for all stages)
7
8
Adjust the pickup position.
Press [Data modify].
6
Item
Fit the nozzles on all the nozzle holders for a head.
To Step 9
EJM8A-E-SMA051111-A01-00
Page 5-11-11-3
Press [Complete].
Press [Performance info]. Press [Reset]. Press [Run].
Press [Yes].
Press [Performance info]. Press [Pick Info]. Press [Error scrn].
Press [Reset].
RemarksItem
12-Nozzle Head Teaching
Press [Next pick posi].
P
ress [RecogReflect]
10
Machinery Part Replacement
9
12
Reset the recognition-error screen.
Reset the production data.
11
From Step 8
Press [Tape feed] to feed a
component to the pickup
position.
Ta
p
e
p
ocke
t
Component
Check the tape pocket is
p
ositioned in the center.
Repeat all the above steps for
each stage.
Mount-position-teaching jig
240 x 216 glass board
EJM8A-E-SMA051111-A01-00
Page 5-11-11-4
Press [Production]. Select the stage to teach.
Press [ESC].
Press [Yes]. Press [Yes].
* The machine parameters are saved automatically when returning to
the main menu.
12-Nozzle Head Teaching
Remarks
13
Item
mounting.
Press [ESC].
Press [Production] to start teaching. * Change double-sided tape for each
Press [Mount position].
14
15
Machinery Part Replacement
Press [Mount pos teach].
• After board recognition is
finished, plug in the light box
and turn on the light.
• When mounting starts, cycle
stop is displayed
automatically.
• When both mounting and
recognition are finished,
return to the main menu and
remove the board and the
light box. The teaching is
finished.
Caution
• To reset an error screen:
Stage A ⇒ Select Tables 1 and
2 and reset the screen.
Stage B ⇒ Select Tables 3 and
4 and reset the screen.
EJM8A-E-SMA051111-A01-00
Page 5-11-11-5