CM602all_EJM8AESM_Service Manual - 第80页
. Check that a warning window appears when the machine is operated (auto run) with the cover open. Installation Machine Installation Item Remark 41 "Servo Switch Warning" window 42 Check the machine cover switc…
. Check that a warning message and
an error message appear when either
of the emergency stop switch is
pressed.
. This warning window appears when the
machine is attempted to be operated
with the emergency stop switch pressed.
. An error occurs when the emergency
stop switch is pressed during machine
operation (Power ON).
. To reset the switch, pull it.
. Turn off the servo switch.
Operate the machine. (auto run)
Check that the error message
appears.
40
one for each side, front and rear.
39
"Emergency Stop Error" windo
w
"Emergency Stop Error" windo
w
Check the servo switches.
Installation Machine Installation
Item Remark
37
Check the emergency stop switches:
one for each side, front and rear.
38
"Emergency Stop Warning" window
EJM8A-E-SMA020103-A01-00 Page 2-1-3-11
. Check that a warning window appears
when the machine is operated (auto
run) with the cover open.
Installation Machine Installation
Item Remark
41
"Servo Switch Warning" window
42
Check the machine cover switches.
2 for each side: front and rear
43
"Cover Switch Warning" window
44
Check the tape float sensor detection. (4 pcs.)
Check, cutting off the light beam with
* Use "Machine adjust" "Input check. paper or an equivalent tool
EJM8A-E-SMA020103-A01-00 Page 2-1-3-12
* When the motor power
is off, select "Unlock"
and "Start."
48
a little
.
below:
47
"UNLOCK" (1) Pin change star
t
The head moves inwards and
the support plate moves up.
Lower the dog and pull the plate o
u
The support interlock sensor is show
n
46
Check detection of the width adjustment
Select (1) [Product config] an
d
interlocks. 2 pcs.
(2) [Support pin change].
Installation Machine Installation
45
Check the tape float sensor of each when it is open
stage :when the tape float cover is close
d
Item Remark
(1)
(2)
(1)
Light beam passes.
Light beam is cut.
Dog raised
Dog lowered
EJM8A-E-SMA020103-A01-00 Page 2-1-3-13