CM602all_EJM8AESM_Service Manual - 第81页

* When the motor power is off, select "Unlock" and "Start." 48 a little . below: 47 "UNLOCK" (1) Pin change star t The head moves inwards and the support plate moves up. Lower the dog and pu…

100%1 / 1093
. Check that a warning window appears
when the machine is operated (auto
run) with the cover open.
Installation Machine Installation
Item Remark
41
"Servo Switch Warning" window
42
Check the machine cover switches.
2 for each side: front and rear
43
"Cover Switch Warning" window
44
Check the tape float sensor detection. (4 pcs.)
Check, cutting off the light beam with
* Use "Machine adjust" "Input check. paper or an equivalent tool
EJM8A-E-SMA020103-A01-00 Page　2-1-3-12
* When the motor power
is off, select "Unlock"
and "Start."
48
a little
.
below:
47
"UNLOCK" (1) Pin change star
t
The head moves inwards and
the support plate moves up.
Lower the dog and pull the plate o
u
The support interlock sensor is show
n
46
Check detection of the width adjustment
Select (1) [Product config] an
d
interlocks. 2 pcs.
(2) [Support pin change].
Installation Machine Installation
45
Check the tape float sensor of each when it is open
stage :when the tape float cover is close
d
Item Remark
(1)
(2)
(1)
Light beam passes.
Light beam is cut.
Dog raised
Dog lowered
EJM8A-E-SMA020103-A01-00 Page　2-1-3-13
. Check that the warning appears as
shown at right when the plate is
pulled and the hook is lowered.
. Each time "SET" is pressed,
[Setup before shipping]
the reading is changed as follows:
P_1　；　0.450MPa
P_2　；　0.600MPa
_　H　；　0.050MPa
. Enter the lowest pressure into P1.
[Specifications]
* When air pressure is affected easily
by factory's conditions, adjust P-1
Air pressure: 0.49MPa
　 and P-2 according to those
conditions.
Size of Inlet: 3/8
Error example:
Amount of air supplied:
The other machines were stopped at the
150L/min
factory finishing time so the main air
Others
pressure rose and exceeded the
8L/min is necessary
maximum limit.
for each bulk feeder
Installation Machine Installation
Item Remark
49
Setup guide
0.4 Mpa.
. It was set before shipping; check only.
50
Check that the air pressure is set t
o
51
Select (2) Floppy diskSelect (1) File management
.
Select [Floppy disk] from
the window at left.
52
Check saving to a floppy disk
(1)
(2)
(3)
(4)
『P_2』
『_　H』
(1)
(2)
[Current reading] [P_1]
EJM8A-E-SMA020103-A01-00 Page　2-1-3-14