CM602all_EJM8AESM_Service Manual - 第840页
Remarks Turn off the power and air supply. Remove the feeder cover. Allen key 3 mm Screw M4 4 pcs. Remove the head upper cover. Phillips screwdriver #2 Truss screw M4 4 pcs. PCB-Warp-Sensor Unit Item 1 2 3 4 Move the fro…
This section describes the procedures for replacing the PCB-warp-sensor amplifier (8-nozzle head spec.)
• Tools
Phillips screwdriver #1
Phillips screwdriver #2
Allen key Long/short
Pipe
Nipper
• Jigs
PCB-Warp-Sensor Unit
6-5-1 PCB-Warp-Sensor-Amplifier Replacement (8-Nozzle-Head Spec.)
Option Part and Accessory Replacement
PCB-Warp-Sensor Unit
6-5
Danger
Warning
Caution
EJM8A-E-SMA060501-A01-01 Page 6-5-1-1
Remarks
Turn off the power and air supply.
Remove the feeder cover.
Allen key 3 mm
Screw M4 4 pcs.
Remove the head upper cover.
Phillips screwdriver #2
Truss screw M4 4 pcs.
PCB-Warp-Sensor Unit
Item
1
2
3
4
Move the front and rear beams towards you.
Option Part and Accessory Replacement
1
2
Rear Front
EJM8A-E-SMA060501-A01-01
Page 6-5-1-2
Remarks
PCB-Warp-Sensor Unit
Item
Option Part and Accessory Replacement
Remove the amplifier connector.
* Amplifier connector CN13
Cut off the cable tie. - (1)
Cut off the cable tie. - (2)
Remove the sensor connector.
5
6
8
7
Remove the amplifier connector.
Cut off the cable tie.
Turn the sensor connector (to the amplifier)
to the left. Remove the connector.
Cut off the cable tie.
EJM8A-E-SMA060501-A01-01
Page 6-5-1-3