CM602all_EJM8AESM_Service Manual - 第862页
Remarks Item Option Part and Accessory Replacement PCB-Warp-Sensor Unit Cut off the cable tie. - (1) Remove the sensor connector. Cut off the cable tie. - (3) Remove the sensor bracket. Wrench M4 M4 x 14L (2 pcs.) 6 5 8 …
Remarks
Preparation
Turn off the power and air supply.
2
Remove the feeder cover.
3
Allen key 3 mm
Screw M4 4 pcs.
4
Item
1
Move the front and rear beams towards you.
Option Part and Accessory Replacement
PCB-Warp-Sensor Unit
1
2
Remove all the support pins.
* Before replacing the sensor, check no polarizing plates are attached to the head camera.
Rear Front
EJM8A-E-SMA060504-A01-00
Page 6-5-4-2
Remarks
Item
Option Part and Accessory Replacement
PCB-Warp-Sensor Unit
Cut off the cable tie. - (1)
Remove the sensor connector.
Cut off the cable tie. - (3)
Remove the sensor bracket.
Wrench M4
M4 x 14L (2 pcs.)
6
5
8
7
Cut off the cable tie.
Turn the sensor connector (to the amplifier)
to the left. Remove the connector.
Cut off the cable tie.
Front
Side
Loosen the two M4x14L bolts.
Remove the bracket.
EJM8A-E-SMA060504-A01-00
Page 6-5-4-3
Remarks
Item
Option Part and Accessory Replacement
PCB-Warp-Sensor Unit
Remove the sensor.
Wrench M4
CB4-18 (2 pcs.)
Install the new sensor.
Wrench M4
CB4-18 (2 pcs.)
Put the sensor bracket back on.
Wrench M4
M4 x 14L (2 pcs.)
10
9
11
Loosen the two special bolts CB4-
18. Remove the sensor.
Install the sensor with two special
bolts CB4-18.
Install the bracket
with two M4x14L bolts.
EJM8A-E-SMA060504-A01-00
Page 6-5-4-4