CM602all_EJM8AESM_Service Manual - 第902页
Lift will Fall! When the coupling is loosened, the lift will fall down. To avoid this, hold the ball screw with a wrench. 6 7 8 If the difference is more than ± 1mm, Tray Shuttle Tray Remarks Item Reference: Jig on the r…
3
4
Jig: FM0558
Palette jig
Phillips screwdriver #2
Allen key 3 mm
Screw M4 2 pcs.
Screw M4 x 10L 8 pcs.
Remarks
Return the lift-axis to the origin.
Mount the palette jigs on the lift table and the replenishment table.
Raise the lift-axis by 422 st.
Item
Tray Shuttle Tray
2
1
Remove the top cover.
422
EJM8A-E-SMA070104-A01-00
Page 7-1-4-2
Lift will Fall!
When the coupling is loosened, the lift
will fall down. To avoid this, hold the
ball screw with a wrench.
6
7
8
If the difference is more than ± 1mm,
Tray Shuttle Tray
RemarksItem
Reference: Jig on the replenishment table.
Specifications:
±1.0mm or less
When the difference in
height between the lift and
the replenishment tables is
+/- 1.0 mm or less,
proceed to Step 12 and
enter the parameter.
Measure the height of the jigs.
5
Allen key 3 mm
Screw M4 4 pcs.
Allen key 4 mm
Wrench 14 mm
Screw M5 6 pcs.
remove the coupling.
Holding the ball screw with a wrench,
Philips screwdriver #2
Screw M4 12 pcs.
open the cover.
Remove the ball screw cover.
Replenishment
table
Lift table
If the cover cannot be
removed
,
hold here.
EJM8A-E-SMA070104-A01-00
Page 7-1-4-3
Tray Shuttle Tray
10
11
12
Enter the measured value into [TL] manually.
Specifications:
±1.0 mm or less
Tighten the lift-axis motor coupling.
Specifications:
Tightening torque:
8.0N・m
A=2mm±1mm
Allen key 5mm
Ruler 150mm
M6 6 pcs.
After tightening the coupling, confirm the height.
Item Remarks
9
Measure the height of the jig.
Specifications:
±1.0 mm or less
Adjust the height of the lift table, turning the wrench.
A
To
l
o
w
e
r
To
raise
Wrench
+
-
EJM8A-E-SMA070104-A01-00
Page 7-1-4-4