CM602all_EJM8AESM_Service Manual - 第904页
• Jigs 30 • Tools None Phillips screwdriver #2 Precision screwdriver Nipper Allen key M4 Teaching Assembly/Adjustment Removal/Disassembly Lift-axis Driver Replacement Min. 20 Min. 2.0 50 0 Min. kgs Tray Min. Shuttle Tray…
Tray Shuttle Tray
10
11
12
Enter the measured value into [TL] manually.
Specifications:
±1.0 mm or less
Tighten the lift-axis motor coupling.
Specifications:
Tightening torque:
8.0N・m
A=2mm±1mm
Allen key 5mm
Ruler 150mm
M6 6 pcs.
After tightening the coupling, confirm the height.
Item Remarks
9
Measure the height of the jig.
Specifications:
±1.0 mm or less
Adjust the height of the lift table, turning the wrench.
A
To
l
o
w
e
r
To
raise
Wrench
+
-
EJM8A-E-SMA070104-A01-00
Page 7-1-4-4
• Jigs
30
• Tools
None
Phillips screwdriver #2
Precision screwdriver
Nipper
Allen key M4
Teaching
Assembly/AdjustmentRemoval/Disassembly
Lift-axis Driver Replacement
Min.
20 Min.
2.050
0
Min.
kgs
Tray
Min.
Shuttle Tray
This section describes the procedures for replacing the lift-axis driver.
Total Time Part Weight
7-1-5
Dange
r
Warning
Caution
EJM8A-E-SMA070105-A01-00
Page 7-1-5-1
2
1
90578
Remarks
Power down the machine.
Phillips precision
screwdriver
Connector screw
Item
Shuttle Tray
Phillips screwdriver #2
Screw M4 4 pcs.
Remove all connectors from the front board.
Remove the connector from the right side of the box.
3
4
Tray
Remove the front and the side covers from the control box.
EJM8A-E-SMA070105-A01-00
Page 7-1-5-2