User Manual - SIPLACE Glue Feedeer - 第82页
5 Cleaning and Maintenance 5.4 Cleaning and Inspecting the Gluing Unit 82 User Manual SIPLACE Glue Feeder 05/2020 5.4.3.5 Fastening the Nozzle Heating ► Place the nozzle heating onto the jet block and align this straight…
5 Cleaning and Maintenance
5.4 Cleaning and Inspecting the Gluing Unit
User Manual SIPLACE Glue Feeder 05/2020 81
5.4.3.3 Attaching the Cartridge Pipe
► Place the cartridge pipe from behind onto the
thread of the jet block.
► Use a size 8 mm open-ended wrench to turn and
fasten the cartridge pipe in a clockwise direction.
► Align the cartridge pipe centrally and straight in
relation to the back, so that the cartridge can be
correctly screwed into place.
► Fix the cartridge pipe with one hand in this posi-
tion and then screw the lock tight.
5.4.3.4 Fitting the Dispenser Nozzle
NOTICE
Flat nozzle and needle nozzle
Depending upon its purpose, the glue feeder can be used with either a flat or needle
nozzle. The procedure for fitting the dispenser nozzle is the same in both types and is illus-
trated using the example of the flat nozzle in the following section:
► Place the dispenser nozzle centrally onto the
thread of the jet block.
5 Cleaning and Maintenance
5.4 Cleaning and Inspecting the Gluing Unit
82 User Manual SIPLACE Glue Feeder 05/2020
5.4.3.5 Fastening the Nozzle Heating
► Place the nozzle heating onto the jet block and
align this straight on the cartridge pipe.
► Fit the union nut onto the dispenser nozzle.
► Position the two lugs of the heating key into the
two holes in the union nut.
► Tighten the union nut by turning it clockwise.
► Insert the heating connector into the nozzle heat-
ing, up to the stop.
5 Cleaning and Maintenance
5.4 Cleaning and Inspecting the Gluing Unit
User Manual SIPLACE Glue Feeder 05/2020 83
5.4.3.6 Inserting the Cartridge
Two sizes of cartridge can be used with the Glue
Feeder (10 or 30 ml).
► Adjust the cartridge holder to the size of the cart-
ridge to be used.
1. Then pull out the cartridge holder.
2. Turn the cartridge holder so that the required size
is at the top.
3. Let the cartridge holder engage audibly.
► Screw the front cap off the cartridge.
► Remove the back cap from the cartridge.
► Hold the cartridge against the cartridge pipe and
screw it on to the pipe straight.