wire-bonder.pdf - 第54页
WEST•BOND MODEL 454647E SER IES INSTRUCTION MANUAL 48 PROGRAMMING Learn to Setup Device Available only in the 4500 E mode, this feature is similar to C LO SE C LAMP AT L OOP H EIGHT , and allows the operator to have more…
WEST•BOND MODEL 454647E SERIES INSTRUCTION MANUAL
47
PROGRAMMING
Learn to Setup Device
Position the tool above the second bond. This setting is the distance between the first and second bond in
motor steps.
MOVE BOND #2 of 2: 120 from Bond 1
5=Increase (0.02500”)
8=Y restore
A=Prev option 0=Decrease G=Next option
Æ
PRESS KEY G
Å
A feature available only in the 4500E model mode, the C
LAMP AT LOOP option can help to create a higher,
more pronounced loop shape when the clamps close at LOOP HEIGHT.
4500E
ONLY
Close CLAMP AT LOOP HT above Bond #2:
5=Close
8=Suggest
A=Prev option 0=Open G=Next option
Æ
PRESS KEY G
Å
Search Before Bond 2 is the point where the tool will pause if run in either half-auto mode or if a key is
held in the full-auto mode. From this vantage point the operator can make any last minute changes to the
bond targeting.
Search before Bond #2: 61 from Loop
4=Key in 5=Inch up (0.01271”)
8=Suggest 9=Erase srch
A=Prev option 0=Inch down G=Next option
Æ
PRESS KEY G
Å
Last chance for changes to spacing between bonds.
MOVE BOND #2 of 2: 120 from Bond 1
FINAL 5=Increase (0.01271”)
ADJUSTMENT 8=Y restore 9=Erase srch
A=Prev option 0=Decrease G=Next option
Æ
PRESS KEY G
Å
WEST•BOND MODEL 454647E SERIES INSTRUCTION MANUAL
48
PROGRAMMING
Learn to Setup Device
Available only in the 4500E mode, this feature is similar to CLOSE CLAMP AT LOOP HEIGHT, and allows the
operator to have more control over the loop shape. Closing the clamps at second search is not as
noticeable in most applications, however, if N
UDGE-UP is being used then it becomes absolutely
necessary to have the clamps close at this second search elevation.
4500E
ONLY
Close CLAMP AT SEARCH above Bond #2:
5=Close
8=Suggest
A=Prev option 0=Open G=Next option
Æ
PRESS KEY G
Å
WEST•BOND MODEL 454647E SERIES INSTRUCTION MANUAL
49
ADVANCED PROGRAMMING
Main Edit Menu
MAIN EDIT MENU
EDIT 0=Edit loop motion
4=Repeat last edit 6=Machine setup
7=Device edit 9=Wire type edit
A=Bond edit G=Learn mode
1 or 3 = Exit Edit
2 = Go To Device/Type
4 = Repeat Last Edit
5 = Info
ϑ To call “Main Edit Menu”
From the “Home” Menu, Press 4 (Edit)
Key Format:
Escape
1
Go To
Device/Type
2
Home
3
Repeat
Last Edit
4
Info
5
Machine
Setup
6
Device Edit
7
8
Wire
Type Edit
9
Bond Edit
A
Edit
Loop
Motion 0
Learn Mode
G