OCP-02502-G - 第28页

VITRONICS REFLOW SOLDERING SYSTEMS EM 02502- G 15-Nov-00 (c) PAGE Operator’s Manual 27 RAIL CHAIN LUBRICAT ION The Rail Chain Lubrication Option provides smooth operation and will extend the life of the rail chain convey…

VITRONICS REFLOW SOLDERING SYSTEMS

EM 02502-G 15-Nov-00 (c) PAGE Operator’s Manual

BOARD DROP ALARM

If a board does not arrive under the Offload sensor when expected, at the end of

the countdown period the board drop alarm will be activated unless the Board Drop

Alarm has been “Disabled”. Refer to “Alarm Levels & Settings”.

Any dropped boards should be removed from the process tunnel. Upon restarting

the product definition, the board counts will be reset to zero.

CAUTION

WHEN REMOVING BOARDS FROM THE PROCESS TUNNEL, TAKE SUITABLE

PRECAUTIONS AGAINST THE POSSIBILITY OF INJURY FROM

THE HOT PARTS WITHIN THE HEAT ZONE.

BOARD JAM ALARM

If a space between boards does not occur under the Offload sensor when

expected, (based on the ‘board length’ and the speed of the conveyor) the Board

Jam Alarm will be activated unless the Board Jam Alarm has been set to “Off”.

QUICK COOL DOWN

Selecting the QUICK COOL DOWN symbol will start the cell

fans while the HOOD is open without heat applied to the cells.

(Select this symbol again to stop the fans)

QUICK COOL DOWN aids the cooling of the process tunnel, and is possible only

in the SHUTDOWN state.

BE CAREFUL OPENING THE HOOD, THE AIR AND THE OVEN

SURFACES ARE HOT !!

VITRONICS REFLOW SOLDERING SYSTEMS

EM 02502-G 15-Nov-00 (c) PAGE Operator’s Manual

RAIL CHAIN LUBRICATION

The Rail Chain Lubrication Option provides smooth operation and will extend the

life of the rail chain conveyor by periodically applying lubrication to the chain during

oven operation. The Oven MUST be running for ANY Lubrication to take place.

This Option can be used automatic or manual.

RAIL CHAIN LUBRICATION STATUS

The present status of the Rail Chain Lubrication System

can be displayed by selecting the "Lubrication" symbol

at the top of the Oven Operating Screen.

(This symbol will be displayed at the bottom of the screen during

the Lubrication Process)

The Lubrication Status dialogue box will be displayed:

Rail Lubrication System Information is displayed, including:

1) Automatic chain lubrication is enabled (or disabled).

2) Lubrication process is on (or off).

3) Number of chain cycles before the automatic lube process starts.

4) Number of lubrications before a low oil warning is displayed.

VITRONICS REFLOW SOLDERING SYSTEMS

EM 02502-G 15-Nov-00 (c) PAGE Operator’s Manual

RAIL CHAIN LUBRICATION

The automatic lubrication starts when the chain has completed the number of

cycles between lubrications.

The Lubrication Icon (symbol) is displayed with the time remaining in the

Lubrication Process, as a predetermined quantity of lube oil is applied to the rail

chain.

The conveyor will start at minimum speed. 5 seconds later, lube oil will be applied

for two complete cycles of the chain.

REFILLING THE OIL RESERVOIR

The oil reservoir needs to be refilled (with the proper lubricant) when a warning

message "check chain lubricant level in tank, refill if necessary." is displayed and

the "low oil symbol" is displayed on the Graphics View Screen.

NOTE

IT IS POSSIBLE TO SELECT REFILL ONLY IF NO LUBRICATION IS

PRESENTLY IN PROCESS.