09_SM481_Service_Manual Feeder_Base.pdf - 第12页

Advance d High Speed Flex i ble Mounter 9-8 9.3. Feeder Base Bo ard 9.3.1. Require d T ool s  W rench  T wre nch (other tool s supplied) o r hex w rench  Screw d r iver with “ + ” shaped tip 9.3.2. Feed er base board …

100%1 / 13
Feeder Base
9-7
6. Remove the set screws (M8- 7sets) and the chip cover. Unscrew the set screws (M8- 4 sets) and
remove the chip cover (on both side of the feeder base).
7. Replace the feeder base module with a new one.
Reference
The part number of the feeder base module is J90571018A
8. The assembling is performed in the reverse order of disassembling.
9. Assemble and secure the feeder base module so that the parallelism of the feeder base module
may become less than 0.1mm.
Caution
Install the feeder origin setting jig on each of the #13, #30
and #47 slot of the feeder stations and obtain the Y-axis
coordinates. Ensure that the difference between the
maximum and minimum Y-axis coordinates may become
less than 0.1mm.
10. Turn on the main switch on the front side of the machine and open the air valve. And
thenboot the PC once the assembling is completed.
Fitting
Air Tube
Advanced High Speed Flexible Mounter
9-8
9.3. Feeder Base Board
9.3.1. Required Tools
Wrench
T wrench (other tools supplied) or hex wrench
Screw driver with “+” shaped tip
9.3.2. Feeder base board Replacement Procedure
1. Open the acrylic cover at the front of the machine.
2. Unscrew the fixing bolts securing the cover at the front of the feeder base and remove
it.
3. Remove the connector connected to the feeder base board.
Feeder Right
Cover
Feeder Left
Cover
Right Feeder
Base Board
Left Feeder
Base Board
Feeder Base
9-9
4. Replace the board with a new one.
Reference
The part number of the left board is J9060347A
The part number of the right board is J9060348A
5. The assembling is performed in the reverse order of disassembling.
6. Turn on the main switch on the front side of the machine and open the air valve. And
thenboot the PC once the assembling is completed.
7. Check the input and output of the feeder base and install the tape feeder. Then check if it works
properly.