00195642-01_IM-SetupCenter-3.0_EN - 第75页
Installation DATALOGIC Scanner Configuration Steps to perform after Installation Installation Manual SIPLACE Setup Center V3.0 75 X The scanner-ID is now incremented to the next unu sed ad dress. Activate the next Scanne…
Installation
Steps to perform after Installation DATALOGIC Scanner Configuration
74 Installation Manual SIPLACE Setup Center V3.0
By first configuration of a scanner by this Setup Center, the cradle address is set by random.
X Click the barcode trigger-key on scanner one time to activate it from standby-mode.
X Put the scanner into the cradle and click “Start” to set up the scanner.
By first configuration the cradle is unknown for Setup Center.
X Validate the message with “Yes” to continue.
X Remove the scanner from cradle and press the “Enter”-key on scanner to check the connection to
Setup Center.
X Click “Yes” to connect another scanner with Setup Center.
ATTENTION:
Configure each scanner again, if you moved the cradle from another Setup Center computer.
Installation
DATALOGIC Scanner Configuration Steps to perform after Installation
Installation Manual SIPLACE Setup Center V3.0
75
X The scanner-ID is now incremented to the next unused address. Activate the next Scanner from
standby, put it into cradle and click “Start”.
If you manually enter an already used address, Setup Center will warn you by following.
ATTENTION:
Do not scan or press keys at an already connected scanner, while configuring a new one.
ATTENTION:
Make sure that the cradle address and scanner-ID are unique in a factory.
ATTENTION:
It’s not recommended to move a cradle from one Setup Center Computer to another. In this
case, please configure each scanner again.
Installation
Steps to perform after Installation DATALOGIC Scanner Configuration
76 Installation Manual SIPLACE Setup Center V3.0
6.4.3.5 Changing the cradle address
If you want to change the cradle address in the future, you should notify that all previously connected
scanners will be disconnected. You have to reconfigure them again.
X Click “Start” to continue.
X Click “Yes” to confirm the change.