00196626-06_AI_Portalmodularitaet_SX12_de_en - 第96页

Fitting the Gantry Installing the Gantry Fitting the Short End Position Buffe r 96 Gantry Modularity Portalmodularität 3.4.1 Fitting the Short End Position Buffer The short end position buffer m ust be fitted in SIPLACE …

Fitting the Gantry

Transportation Locks and Tilt Guard Installing the Gantry

Gantry Modularity Portalmodularität 95

Remove the tilt guard and move in the gantry

The docking hooks are hooked into place on the left (1)

and right (2) sides.

The gantry carrier with the gantry is now fixed reliably

onto the machine.

► Open the tilt guard (1).

► Push the gantry (2) into the machine so that both

sides of the gantry rest on the two linear guides.

► Move the gantry lift with the gantry carrier out of the

location.

► Move the gantry (2) into the machine so that the trail-

ing cable (1) can be pulled underneath, through the

gantry.

Fitting the Gantry

Installing the Gantry Fitting the Short End Position Buffer

96 Gantry Modularity Portalmodularität

3.4.1 Fitting the Short End Position Buffer

The short end position buffer must be fitted in SIPLACE SX machines with two gantries. This buffer

needs to be removed and replaced with the long end position buffer in SIPLACE SX machines with one

gantry at location 1.

► Carefully place the flat ribbon cable (1) and the pneu-

matic connections (2) over the gantry.

► Remove the black plastic foil. A cable tie fixes the

black plastic foil to the trailing cable (1).

► Fit the end position buffer (2) to the left side.

► Fit the end position buffer (3) to the right side. The

safety switch (4) for the buffer monitoring function

must engage in the Schmersal switch.

► Tighten the fastening screws (1) for both buffers.

Fitting the Gantry

Fitting the Short End Position Buffer Connecting the Trailing Cable

Gantry Modularity Portalmodularität 97

3.5 Connecting the Trailing Cable

► Remove the cover (1) over the gantry interface. To do

this, loosen the two fastening screws on the right side

and carefully open the bottom left pushbutton.

► Fit the trailing cable holder (1) from below, to the gan-

try distributor holder. See the following section.

► Carefully place the flat ribbon cable and the pneumat-

ic hoses to one side (2).

► Make sure you do not damage the cables and hoses.

► Take care that the alignment is correct and that all ca-

bles and hoses are run above one another and even-

ly.

NOTICE!

When fitting the trailing cable, make sure that the heat-

shrinkable sleeve (1) protects the flat ribbon cable under

the Y sensor module holder.