00198596-02_JC_3M_C - 第3页
www.asm-smt.com Equipment required for C&P20 P2/M3 head maintenance (3-monthly) 1 Mount the C&P20 P2/M3 head 2 Remove the holding circuit / orifice plate 3 Clean the return unit 4 Clean the Z-axis 5 Clean / lubri…
All names identified by ® are registered trademarks of ASM Assembly Systems GmbH & Co. KG. The remaining trademarks in this publication may be trademarks whose use by third parties
for their own purposes could violate the rights of the owner.
We have reviewed the contents of this publication to ensure consistency with the hardware and software described. Since variance cannot be precluded entirely, we cannot guarantee full
consistency. However, the information in this publication is reviewed regularly and any necessary corrections are included in subsequent editions.
Copyright © ASM Assembly Systems Technical data subject to change
ASM Assembly Systems GmbH & Co. KG
Rupert-Mayer-Straße 44
81379 Munich
Germany
Item no.: 00198596-02
www.asm-smt.com Printed by ASM Assembly Systems
www.asm-smt.com
Equipment required for C&P20 P2/M3 head maintenance (3-monthly)
1 Mount the C&P20 P2/M3 head
2 Remove the holding circuit / orifice plate
3 Clean the return unit
4 Clean the Z-axis
5 Clean / lubricate the Z-axis linear guide
6 Clean / lubricate the DP linear guide
7 Clean / lubricate the DP drive bearing
8 Clean / lubricate the race way and clean the Z-axis jaw and light barrier
9 Clean the DP deflection area
10 Replace the filter disks
11 Mount the holding circuit / orifice plate
12 Clean the component sensor
13 Check / replace the hose for the exhaust air
14 Finishing the head maintenance
15 Appendix: Maintain the holding circuit
16 Appendix: Maintain the aperture ring
17 Appendix: Prepare the multipette
18 Appendix: Clean-up the multipette
Table of Contents
www.asm-smt.com
Table of Contents