00198596-02_JC_3M_C - 第38页

www.asm-smt.com

9 3-monthly C&P20 P2/M3 Clean the DP deflection area 2 min 1 / 1

Refer to safety instructions in user manual before commencing Maintenance

NOTICE! ESD guidelines are to be followed Tool:

T21

Wear Part: Consumables:

C5, C22

www.asm-smt.com

1 Turn the head right side up and put the

head stand flat on the table.

2 Rotate segment 1 to the service window

and align it with the service mark.

3 Clean the deflection area using a slightly

moistened cleaning stick.

4 Turn the star to the next segment. 5 Repeat step 3 to 4 for each segment.

www.asm-smt.com

10 3-monthly C&P20 P2/M3 Replace the filter disks 5 min 1 / 2

Refer to safety instructions in user manual before commencing Maintenance

NOTICE! ESD guidelines are to be followed Tool:

T21, T66

Wear Part:

Consumables:

www.asm-smt.com

1 Put the head stand in the upright position

and turn the head right side up.

2 Place the tool onto the nozzle interface so

the pin is in one of the four notches.

3 Press the guide sleeve against the DP un-

til the segment spring is fully compressed

and hold it there.

4 Twist the handle clockwise while pushing

it into the filter disk until it is completely in

and then twist another quarter turn.

5 Hold the guide sleeve against the DP

while pulling back the handle to remove

the filter disk from the segment.

6 Hold the guide sleeve and pull down the

handle to remove the filter disk.