00900068-02_SM_ASM_ProcessLens_EN - 第22页

ASM Proces sLens Single - l ane 03/2020 Edit ion 22 3.3.1 Change the l ow R inglight board Require ment: ● Lo w R ingli ght ass embl y is dismantled . Ke y: 1) Screw (10 x) 2) Cover Figure 3-9 : L ow Ringlight assembly 1…

100%1 / 92
ASM ProcessLens Single-lane 03/2020 Edition
21
Key:
1) Screw (4 x)
Figure 3-8: Low Ringlight assembly
2. Remove the screws (1) on the low Ringlight assembly using an Allen key size 2.5.
CAUTION
Different types of screws
There are two different types of screws. The ones in the back are shorter than the ones
in the front.
3. Remove the low Ringlight assembly and place it on a service table.
Installation
Follow the removal instructions in reverse order for installation.
ASM ProcessLens Single-lane 03/2020 Edition
22
3.3.1 Change the low Ringlight board
Requirement:
● Low Ringlight assembly is dismantled.
Key:
1) Screw (10 x)
2) Cover
Figure 3-9: Low Ringlight assembly
1. Unscrew all screws (1) with an Allen key size 2.5.
2. Remove the cover (2) of the low Ringlight assembly
Key:
1) Screw (4 x)
2) Low Ringlight board
3) Plastic ring
Figure 3-10: Low Ringlight assembly (dismantled)
3. Unscrew the screws (1) using a Philips screwdriver.
4. Remove the plastic ring (3) and place it on the service table.
5. Change the low Ringlight board (2).
Installation
Follow the removal instructions in reverse order for installation.
ASM ProcessLens Single-lane 03/2020 Edition
23
3.4 Change the high Ringlight assembly
Key:
1) Screw (3 x)
Figure 3-11: High Ringlight assembly (from below)
Requirements:
● Machine is switched off.
● It is advisable to dismantle the low Ringlight assembly as well for better access.
● Use a T shaped Allen key to carry out this task.
1. Unplug the connector
2. Unscrew the screws (1) using an Allen key size 2.5.
Small screws
The screws are very small. When the screws fall into the machine they may damage it.
Make sure the screws don’t fall into the machine.
Installation
Follow the removal instructions in reverse order for installation.