00900068-02_SM_ASM_ProcessLens_EN - 第40页

ASM Proces sLens Single - l ane 03/2020 Edit ion 40 3.14 Changing the conve yor motor Require ment: ● Machine is switche d off . Figure 3- 41 : Overview of the conveyor motor Ke y: 1) Conve yor m otor belt 2) Conve yor m…

100%1 / 92
ASM ProcessLens Single-lane 03/2020 Edition
39
Key:
1) Measurement point
Figure 3-39: Conveyor belt
11. Check the tension of the belt at the measurement point using a tension meter. The tension
should be 250 +/- 10 Hz.
12. The steps for the other conveyor system are the same.
Installation
Follow the removal instructions in reverse order for installation.
3.13.1 Check the function of the conveyor belt
Requirements:
● Machine is switched on.
● Inspection circuit board is placed at the beginning of the machine.
Figure 3-40: Diagnostic page
1. Go to the diagnostic page.
2. Click on the tab "Unit function".
3. Go to the section "Conveyor".
4. Click the button "PCB In" and the button "PCB Out".
ASM ProcessLens Single-lane 03/2020 Edition
40
3.14 Changing the conveyor motor
Requirement:
● Machine is switched off.
Figure 3-41: Overview of the conveyor motor
Key:
1) Conveyor motor
belt
2) Conveyor motor
3) Width adjustment
belt
4) Width adjustment
motor
Key:
1) Connectors for the conveyor
motor
2) TSP400
Figure 3-42: TSP400
1. Disconnect the connectors from the TSP400.
ASM ProcessLens Single-lane 03/2020 Edition
41
Key:
1) Screw (4 x)
2) Gear
3) Conveyor motor belt
Figure 3-43: Conveyor motor (from back)
2. Unscrew the screws (4 x) using an Allen Key size 4.0.
3. Take off the conveyor motor belt.
4. Take out the motor of the machine
Key:
1) Conveyor motor
2) Gear
3) Screw
Figure 3-44: Conveyor motor
5. Unscrew the screw off the gear of the old motor and replace it onto the new motor using an
Allen Key size 4.0.
6. Put the motor back in place.
7. Put the belt on and tighten the screws.
8. Connect the connectors to the TSP400.
Installation
Follow the removal instructions in reverse order for installation.